User manual SMART DEVICES MOVIETIMES 3-1-99

[. . . ] 18+'+/'TM +)+6#. *10'00170%'4 Installation & Operation Manual Please leave this manual with the customer after installation 3/1/99 Glossary of terms used in this manual. TELCO KSU/PBX Telephone company line that comes to your building. A telephone system that has multiple lines. May be mechanical buttons or electronic. The wall power pack furnished in North America. [. . . ] This jack is used by the factory to load instructions to the internal computer. If program upgrades are available in the future, your machine may be upgraded to the new software by returning it to the factory to load the new operating program. Note: You must delete a message before recording a new message. This is necessary because your new message may be shorter than the old one and the last part of the old message will remain. Deleting the message restores a blank memory box, ready for the new message. Maximizing the capability of the MovieTimeS. This digital answering device has 24 message boxes for show times on 24 screens. If you have a 30 screen complex, often a movie is played in interlock on multiple screens. We suggest you mention the movie once and use a show times box to give the show times for all showings. Failure to enter a password in 20 seconds, or after the end of the message results in a disconnection. NOTE: When control has been seized from the Remote, a busy signal is heard on the Local telephone you are using. Once the unit is in Command Mode the user may start entering commands. All commands start by entering "*" and end by entering a "#". After each valid command, a single success beep sounds, invalid entries are indicated by an double beep error tone. NOTE: Seizing control causes any calls in progress on the other line to be disconnected. MESSAGE RECORD The Message Record commands allow the user to record one of the available messages. The available messages and message lengths vary with the Message Table and installed memory, see the Message Table command for more information. After the command is entered, the MovieTimeS plays a steady series of short beeps (ready tones) At any point after the ready tones begin, the user may enter " * " to start the recording. Recording continues until the user enters " # " or the maximum record time for the message is reached. At this point, the MovieTimeS plays a success beep and is ready to receive the next command . The error tone sounds if the user attempts to record a message that is not available in the current Message Table or if the selected message has previously been recorded and not erased. Syntax: *50 01# Record Screen Message #1 - #24 *50 24# * 5 0 3 1 # Record Greeting Message * 5 0 3 2 # Record Movie List Message · 11 * 5 0 3 3 # Record Info. Message #3 MESSAGE REVIEW The Message Review commands allow the user to review each of the messages. After the command is entered the requested message plays. After message play completes the user hears the success beep and returns to command mode ready to enter the next command. [. . . ] THESE LIMITS ARE DESIGNED TO PROVIDE REASONABLE PROTECTION AGAINST HARMFUL INTERFERENCE WHEN THIS EQUIPMENT This equipment generates, uses, and can radiate radio frequency energy and, if not installed IS OPERATED IN A COMMERCIAL ENVIRONMENT. and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential environment is likely to cause harmful interference in which case the user will be required to correct the interference AT HIS/HER OWN EXPENSE. LIMITED WARRANTY SMART devices, Inc. warrants that all equipment sold is free from defects in material and workmanship at the time of purchase. The warranty extends 2 years from the date of original purchase and covers parts and labor. [. . . ]