User manual SMART DEVICES SHOWMATION 4

[. . . ] INSTALLATION AND OPERATION Made Right in the U. S. A Installation and Service Manual SHOWMATION Automation Control System Version 4. xx Devices, Inc. 5945 Peachtree Corners East Norcross, Georgia 30071 1-800-45-SMART or 770-449-6698 1 Copyright 2000 by SMART Devices, Inc. 5945 Peachtree Corners East Norcross, GA 30071-1337 SHOWMATION Automation Control System Ver. 4. xx Table of Contents Introduction Electrical Interference Warning Features Description Installation Operating Instructions Front Panel Quick Reference Notes Page 2 Page 3 Page 4 Page 5 Page 6 Page13 Page 15 Page 16 SMART products are designed to deliver unsurpassed quality in workmanship and performance. [. . . ] On all DB25 connectors, secure the connectors with the two thumb screws provided on each connector. Interlock Wiring All interlock wiring should use 2 conductor plus shield cable. Refer to the diagram on Page 11 for the pluggable terminal strip labeled as TB3. You will need 2 of the 2 conductor plus shield cables to connect between each automation that you desire to wire for interlock. The first cable will connect Interlock 1 Start, Interlock 1 Stop, and Interlock Common together. The second cable will connect similar terminals for Interlock 2. Use the the 2 conductors for the Start and Stop functions, and the shield for the Interlock Common. If several automations are wired together for Interlock the cables will just daisy chain from one to the next and so on. Annunciator Panel Wiring The Annunciator Panel wiring is done similarly to the Interlock wiring. You may use the same 2 conductor cable as for the interlock wiring if you like. The shields of the cables will connect to the Com terminal on TB6 of each automation. The hot conductors will attach to the Data terminals on TB3 of each automation. Wire one cable to the DATA IN LO and DATA IN HI terminals. Wire the other cable to the DATA OUT LO and DATA OUT HI terminals. You may only wire up to 32 automations together. Run cables from any of the automations to the location where the Annunciator panel will be mounted. 9 SHOWMATION AUTOMATION Controller Installation Mount the Controller in the console as shown in this diagram. The power transformer should be at the TOP or RIGHT. Please note that the the metal back plate is NOT symmetrical and cannot be turned upside down. The PC board will only mount one way on the panel. There are four mounting holes on the metal back plate which will pass #8 machine screws. These are accessible without removing the PC board from the metal panel. The power cord may be plugged in or the plug may be cut off for direct wiring to a 120VAC source. Power Connections F12 & F13 MDL2 Fuse Slow Blow DB25 cable from Operator Panel DB25 cable from Showgrammer II 10 INSTALLATION AND OPERATION Controller Wiring Information This page shows the functions for the 6 position pluggable terminal strips. If you are controlling a higher current device, then use an external relay of the proper capacity controlled by the on board relay. [. . . ] This is accomplished by simply setting the Interlock selector switch on each Front Panel to the appropriate position. You can set up any combination of screens for interlock in this way. While running, the Interlock state can not be changed accidentally. The only time the Interlock state can be altered is in STOP mode. [. . . ]