User manual SMC 2004USB-CABLE

[. . . ] Insert the SMC CD-Rom into the CD-ROM drive and find the installation program. (This should be in directory D:\SMC. exe) 3. The InstallShield Wizard will guide you through step-by-step to complete the installation process. A window will appear asking if you want to set the IP address for the USB Network Adapter. [. . . ] Expand the desktop and select the drive, folder, file or printer you want to share. Move your mouse cursor and click right button on the resource. Select Shared As and enter the Shared Name to be recognized by other computers. Note: Other people will only be able to share files that you select to be shared. Until you have chosen these files, other users will not be able to see any files or folders on your PC. The quickest way to set this up to to allow other users to share your entire hard drive rather than selecting individual folders. Step 3 Access Internet through Ethernet -TCP/IP Setup: With the SMC EZ Connect USB Cable, you can access the Internet through an Ethernet network. We need to construct a USB LAN and an Ethernet LAN environment, as the diagram shows below: Computer B Computer C English e. For example, choose Full to give the complete access right to this resource or Read-Only to give others the read-only right to the resource. Click Apply and then OK. Laptop English Router Internet USB/USB Network Bridge cable www Ethernet-LAN USB-LAN Network Construction -Computer A: Conects Computer B with EZ Connect USB Cable. -Computer B: The Bridge Computer which connects Computer A through EZ Connect USB cable and connects Computer C with an Ethernet Adapter. -Computer C: One PC of the Ethernet LAN, connects Computer B with an Ethernet Adapter and can access the Internet directly. Step 4 Installing the SMC EZ connect USB Bridge Driver: The bridge computer is the main computer in the network. There can only be one Bridge computer in the network, It is very important when you are installing the software to only install the Bridge drivers on one of the computers. The InstallShield Wizard will pop-up a Question Window as shown below. TCP/IP Setup on Computer A When all installation processes are completed, you have to specify an IP address , Subnet Mask and Gateway on Computer A: 1. Click the Start menu, point to Setting\Control Panel. In Configuration tab, select TCP/IP -> SMC EZ Connect USB Bridge Adapter, then click Properties. In IP Address tab, please choose "Specify an IP Adress", and fill in the IP address and Subnet Mask value properly. These information should be from your MIS people and make sure this IP Address which is not in use of your Ethernet, or it will cause a network failure. In Gateway tab, you must specify a proper value. This IP Address of Gateway should be the same with the other Computers in the Ethernet. After you install this Bridge Driver on Computer B, there will be one more protocol: SMC EZ Connect USB Bridge Adapter in the Network Configuration. This is a routing protocol, you can use it to bridge between an USB LAN and an Ethernet LAN. 4. When complete all these TCP/IP setup processes, you have to restart your computer again. After that, the Computer A can use the EZ Connect USB Cable to connect Computer B to access the resources of Ethernet (File , CD-ROM, and Scanner sharing) and execute all the functions on Internet (WWW, Email, FTP, Telnet, Gopher. . . etc. ). English English Driver Uninstallation Follow the steps below to remove the the SMC EZ Connect USB Network Bridge driver from Windows system: 1. [. . . ] No part of this document may be reproduced or transmitted in any form by any means, electronic or mechanical, including photocopying, recording or information recording and retrieval systems without the express written permission of the manufacturer. All brand names and product names used in this document are trademarks, or registered trademarks of their respective holders. FCC Statement This device generates and uses radio frequency and may cause interference to radio and television reception if not installed and used properly. This has been tested and found to comply with the limits of a Class B computing device in accordance with the specifications in Part 15 of FCC Rules. These specifications are designed to provide reasonable protection against such interference in a residential installation. [. . . ]