User manual SMC 2652W SI

[. . . ] · 802. 11 compliant wireless Ethernet adapters with TCP/IP compatible protocol installed. · Difficult to wire environments - Old buildings and open areas where wiring is difficult · Frequency changing environments - Retailers, manufacturers and banks who frequently rearrange the workplace and change location. · Web browser for configuration. Installation: 1. Select a site - Choose a proper place for your SMC2652W Access point. In general, the best location to place the access point is at the centre of your wireless coverage area, within line of sight to all your mobile stations. Attach the Antenna - Screw the antenna into the antenna connector (ANT) on the back panel. [. . . ] enter the user name "default" and the password "WLAN_AP". This will take you to the home page. 5. Click on "AP information MIB", "AP control MIB", "TCP/IP settings" or "change password" to select the page required. Encryption: Click Encryption icon for the WEP setting. The information MIB screen displays the categories of information shown above. WEP: For more secure data transmission, set the "WEP" to "Wep_128" or "WEP_64" to ensure wireless network security. The advanced wired equivelant privacy (WEP) is implemented in this device to prevent unauthorised access. The 128 bit setting gives a higher level of security but the setting must be the same as other clients in your wireless network. (default: disabled) English English In the "AP control MIB page", set the parameters and then double click on "apply" to implement the settings. DS channel - Set the channel number as the operating radio channel. Note: the available channel settings are displayed to the right of the "DS channel" field. Local regulations determine which channels are available. ETSI:1-13, france:10-13, Spain:10-11, MKK: 1-14. SSID: This should be set to the same value as other stations in your network. (default: "Wlan") RTS Threshold: et the RTS threshold to the same as that used by other devices in your network. (default:2305, which means disabled) Key entry - This field can be set to "passphrase" or "manual Entry". The "passphrase" means the key elements will be auto generated by the internal algorithym according the string defined in the passphrase field. The "Manual Entry" means the key elements allow/need user key in by manually. (2 hexadecimal digitals in each block) Passphrase - The security key for WEP encryption is generated from your Passphrase string, so it should be the same as all the otherstations in your network. 64-Bit manual Entry: Key1-4 - each key ID contains 10 HEX digits. All wireless devices must have the same key ID elements values to communicate. Key ID - Choose the Key ID that has the encryption string you prefer. All wireless devices must have the same Key ID element values to communicate. Key 1 - Key ID value contains 26 HEX digits. [. . . ] Push in the reset button located on the back of the SMC2652W. English English ii. While holding in the button, apply power to the AP iii. Wait until both the RF activity LED and the RF link LED both start to flash on and off together. Rlease the push button and the LED's will turn off. [. . . ]