User manual SMC 7004VWBR

[. . . ] BarricadeTM Router Wireless Cable/DSL Broadband Wireless Cable/DSL Broadband Router N N N N N N N N N Multi-user Internet access via single user account EZ 3-Click Installation Wizard IEEE 802. 11b compliant Wireless operation at 11, 5. 5, 2, or 1 Mbps Integrated 4-port 10/100 Mbps switch Configurable parental control Stateful Packet Inspection (SPI) and Denial of Service (DoS) support Supports a wide variety of Internet applications Virtual Private Network (VPN) using PPTP, L2TP, IPSec pass-through User Guide SMC7004VWBR BarricadeTM Wireless Cable/ DSL Broadband Router User Guide From SMC's Barricade line of Broadband Routers Sept 2002 Revision Number: R01 COMPLIANCES FCC - Class B This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with instructions, may cause harmful interference to radio communications. However, there is no guarantee that the interference will not occur in a particular installation. [. . . ] Click "OK" to complete the installation procedure and restart your PC to enable the TCP/IP protocols. The operating system may prompt you to restart your system. Click "Yes" and the computer will shut down and restart. 5-2 CONFIGURING CLIENT TCP/IP Windows 2000 1. Click the "Start" button and choose "Settings, " then click "Control Panel. " 2. Double click the "Network and Dial-up Connections" icon, then "Local Area Connection" icon, and press the "Properties" button in the "General" tab. Click the "install. . . " button to add the network component to your PC. Double click on "Protocol" to add the TCP/IP protocol. 5-3 INSTALLING TCP/IP 5. Choose "Internet Protocol (TCP/IP)" in the Network Protocols. Click the "OK" button to return to the Network window. 6. The TCP/IP protocol will be listed in the Network window. Click "OK" to complete the install procedure. 5-4 CONFIGURING CLIENT TCP/IP Setting Up TCP/IP to Work with the Wireless Barricade Windows 95/98/ME 1. Click "Start/Settings/Control Panel. " 2. Highlight the TCP/IP line that has been assigned to your network card on the "Configuration" tab of the Network window. 3. Click the "Properties" button. You may dynamically assign TCP/IP address settings to a client, or you can manually configure a client with address settings to meet your specific network requirements. (Note that the default IP address of the Wireless Barricade is 192. 168. 2. 1. ) 5-5 SETTING UP TCP/IP TO WORK WITH THE WIRELESS BARRICADE Windows 2000 1. Click the "Start" button and choose "Settings, " then click "Control Panel. " 2. Double click the "Network and Dial-up Connections" icon, then "Local Area Connection" icon, and press the "Properties" button in the "General" tab. Select the TCP/IP line that has been assigned to your network card in the "Local Area Connection Properties" window. Click the "Properties" button to set the TCP/IP protocol for the Wireless Barricade. 5. You can dynamically assign TCP/IP address settings to a client, or you can manually configure a client with address settings to meet your specific network requirements. (Note that the default IP address of the Wireless Barricade is 192. 168. 2. 1. ) 5-6 CONFIGURING CLIENT TCP/IP Windows XP 1. [. . . ] SMC is responsible for return shipping charges from SMC to customer. i LIMITED WARRANTY WARRANTIES EXCLUSIVE: IF A SMC PRODUCT DOES NOT OPERATE AS WARRANTED ABOVE, CUSTOMER'S SOLE REMEDY SHALL BE REPAIR OR REPLACEMENT OF THE PRODUCT IN QUESTION, AT SMC'S OPTION. THE FOREGOING WARRANTIES AND REMEDIES ARE EXCLUSIVE AND ARE IN LIEU OF ALL OTHER WARRANTIES OR CONDITIONS, EXPRESSED OR IMPLIED, EITHER IN FACT OR BY OPERATION OF LAW, STATUTORY OR OTHERWISE, INCLUDING WARRANTIES OR CONDITIONS OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. SMC NEITHER ASSUMES NOR AUTHORIZES ANY OTHER PERSON TO ASSUME FOR IT ANY OTHER LIABILITY IN CONNECTION WITH THE SALE, INSTALLATION, MAINTENANCE OR USE OF ITS PRODUCTS. SMC SHALL NOT BE LIABLE UNDER THIS WARRANTY IF ITS TESTING AND EXAMINATION DISCLOSE THE ALLEGED DEFECT IN THE PRODUCT DOES NOT EXIST OR WAS CAUSED BY CUSTOMER'S OR ANY THIRD PERSON'S MISUSE, NEGLECT, IMPROPER INSTALLATION OR TESTING, UNAUTHORIZED ATTEMPTS TO REPAIR, OR ANY OTHER CAUSE BEYOND THE RANGE OF THE INTENDED USE, OR BY ACCIDENT, FIRE, LIGHTNING, OR OTHER HAZARD. [. . . ]