User manual SMC 7301TA

[. . . ] Connect the PC to the RJ-45 LAN connector. Two or more PCs can connect to a multi-port Hub rst and then uplink (cascade) port on the hub must be connected to SMC7301TA LAN port. Plug the power adapter into a wall outlet and into the AC connector on the back of SMC7301TA. The Auxiliary connector is only used to connect a terminal to run the Command Line Interface using the null modem cable. [. . . ] If you choose via DHCP go to step 4, and if you choose via PPP over Ethernet go to step 5. Step 3: If you choose No for the selection of Obtain IP Address Automatically. Enter the following information and then Click Apply. Prole Name: the name that you will use to identify this Internet access prole. WAN IP Address: the IP address of your WAN. WAN IP Netmask: the IP Netmask of your WAN. ISP Gateway IP Address: the IP Address of your ISP Gateway Primary DNS IP Address: the IP Address of your Primary DNS. Secondary DNS IP Address: the IP Address of your Secondary DNS Step 4: If you choose via DHCP for the selection of Obtain IP Address Automatically. Enter the following information and then Click Apply. Prole Name: the name that you will use to identify this Internet access prole. (Optional) Host Name (System Name): the Host Name provided by your system. Step 5: If you choose via PPP over Ethernet for the selection of Obtain IP Address Automatically. Enter the following information and then Click Apply and Test. Prole Name: the name that you will use to identify this Internet access prole. Obtain IP Addresses Automatically: get the IP Address via PPP over Ethernet. Some DSL-based ISPs use PPPoE to establish communications with an end-user. If you are connected to the Internet through a DSL line, check with your ISP to see if they use PPPoE ISP Account Name: the username of your ISP account ISP Account Password: the password of your ISP account (Optional) Service Name: Enter the Service Name provided by your ISP if it is required. (Optional) Access Concentrator Name: Enter the Access Concentrator Name provided by your ISP if it is required. Idle Timeout(0-3600 seconds): The default value of the idle timeout is 120 seconds. It represents the number of seconds of inactivity over the connection: when this value is reached, the SMC7301TA will disconnect the connection. You can change the idle timeout value to anything between 0 to 3600 seconds. But if you select 0, the connection will never time out. [. . . ] ISP Account Name: the username of your ISP account. ISP Account Password: the password of your ISP account. Note: When you click Apply and Test, SMC7301TA attempts to place a call to your Internet Service Provider. Watch the Message window for any messages. If the test is successful, your users will be ready to access the Internet. [. . . ]