User manual SMC SMC7904WBRA-N2 QUICK START GUIDE

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient the receiving antenna · Increase the separation between the equipment and receiver · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected · Consult the dealer or an experienced radio/TV technician for help FCC Caution: To assure continued compliance, (example - use only shielded interface cables when connecting to computer or peripheral devices). Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION STATEMENT: FCC RF Radiation Exposure Statement This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. [. . . ] Click on this button to refresh Dynamic settings. Security Log Save Clear Refresh DHCP Client Log Release Renew 4-38 CHAPTER 5 CONFIGURING CLIENT TCP/IP If you have not previously installed the TCP/IP protocols on your client PCs, refer to the following section. If you need information on how to configure a TCP/IP address on a PC, refer to "Setting Up TCP/IP to Work with the Wireless Barricade" on page 5-5. Installing TCP/IP Windows 95/98/ME 1. Click "Start/Settings/Control Panel. " 2. Double-click the Network icon and select the "Configuration" tab in the Network window. Double-click "Protocol. " 5-1 INSTALLING TCP/IP 5. Select "Microsoft" in the manufacturers list. Select "TCP/IP" in the Network Protocols list. Click the "OK" button to return to the Network window. 6. The TCP/IP protocol will be listed in the Network window. Click "OK" to complete the installation procedure and restart your PC to enable the TCP/IP protocols. The operating system may prompt you to restart your system. Press the "Properties" button in the "General" tab. Select the TCP/IP line that has been assigned to your network card in the "Local Area Connection Properties" window. Click the "Properties" button to set the TCP/IP protocol for the Wireless Barricade. 6. You can dynamically assign TCP/IP address settings to a client, or you can manually configure a client with address settings to meet your specific network requirements. (Note that the default IP address of the Wireless Barricade is 192. 168. 2. 1. ) 5-7 SETTING UP TCP/IP TO WORK WITH THE WIRELESS BARRICADE Configuring Your Computer with Windows 95/98/ME You may find that the instructions here do not exactly match your version of Windows. This is because these steps and screenshots were created in Windows 98. Windows 95 and Windows Millennium Edition are very similar, but not identical, to Windows 98. Configure TCP/IP Settings After you have completed the hardware setup by connecting your devices, you need to configure the computer to connect to the Wireless Barricade. You need to determine how your ISP issues your IP address. Many ISPs issue these numbers automatically using a networking technology known as Dynamic Host Control Protocol, or DHCP. Other ISPs will specify your IP address and associated numbers, which you must enter manually. [. . . ] SMC is not responsible for these items if they are returned with the product. Customers must contact SMC for a Return Material Authorization number prior to returning any product to SMC. Any product returned to SMC without a valid Return Material Authorization (RMA) number clearly marked on the outside of the package will be returned to customer at customer's expense. Customers are responsible for all shipping charges from their facility to SMC. [. . . ]