User manual SMC 7908VOWBRB

[. . . ] When the LED is off, the phone is ON-Hook. · VoIP LED - Shows the VoIP status. When the green LED is solid, the VoIP link is up and connected. When the green LED is blinking, the router is attempting to establish a connection. [. . . ] if you have changed and forgotten the password), press the reset button for 10 seconds. Note that you will lose all your configuration changes when you reset the router to factory defaults. USB 1. 1 Port - Use this port for connecting USB printer or storage device. RJ-11 FXS Phone Ports - Use these ports to connect to a telephone. Ethernet cables Ethernet cables are usually constructed from unscreened, "Cat 5" cable with RJ45 connecters at both ends. Cables of this type can be purchased at most computer retailers. Wireless Troubleshooting · Check that the SSID is the same on the Router and the wireless PC. · Check that the wireless encryption is the same on the Router and the wireless PC. To help debug a problem, turn off encryption in both the Router and wireless PC until you can establish a connection. After a change in encryption, some PCs may have to be restarted. · The wireless PCs must be set to Infrastructure mode to work with a Router. · If your computer has both a wired and wireless connection installed, ensure that the wired Ethernet cable is unplugged. · Check that the Router WLAN LED is on, to indicate that Wireless networking is enabled. To enable wireless networking, go to the Router Wireless page and enable Wireless Networking. · If there are a number of wireless networks within range, then you may experience poor wireless performance if the wireless channels are too close together. Ideally, neighbouring wireless networks should be at least 5 channels apart. The wireless channel is controlled by and set in the Router. · The Router has a feature called MAC Filter which controls which wireless PCs have access to the wireless LAN. If this feature is enabled, then ensure that the MAC address of your wireless PC card is listed in the MAC Filter page. Information furnished by SMC Networks, Inc. (SMC) is believed to be accurate and reliable. However, no responsibility is assumed by SMC for its use, nor for any infringements of patents or other rights of third parties, which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of SMC. SMC reserves the right to change specifications at any time without notice. [. . . ] SSID or WEP) of your Router from a wireless PC, then you may lose contact with your Router. To re-establish the wireless connection, change the wireless settings of your PC to be the same as the Router. 5. To create a wireless network, the Router and wireless PCs must have the same SSID and encryption settings. The default wireless settings for the Router are shown below: · SSID - Router default is SMC The SSID is the name given to your wireless LAN. [. . . ]