User manual SMC SMCFS2601

[. . . ] This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. CE MARK DECLARATION OF CONFORMANCE FOR EMI AND SAFETY (EEC) This is a class A product. [. . . ] The port is operating at 10 Mbps. ­ 13 ­ Rear Panel CHAPTER 2 | Hardware Description Table 1: System and Port Status LEDs (Continued) LED 1000M Condition On Green Off Status The port is operating at 1000 Mbps. The port is operating at 10 or 100 Mbps. RJ-45 PORTS The switch contains 24 10/100 Mbps RJ-45 ports and 2 10/100/1000 Mbps RJ45 ports. All ports support automatic MDI/MDI-X operation, so you can use straight-through cables for all network connections to PCs or servers, or to other switches or hubs. Each of these ports support auto-negotiation, so the optimum transmission mode (half or full duplex), and data rate (10, 100 or 1000 Mbps) is selected automatically. Each port also supports IEEE 802. 3x auto-negotiation of flow control, so the switch can automatically prevent port buffers from becoming saturated. REAR PANEL The rear panel of the switch features the AC power socket. Figure 3: SMCFS2601 Switch Rear Panel 100-240V~ 50/60Hz 0. 6A AC POWER SOCKET Connect the female connector of the power cord to the socket on the switch, and the male connector to the AC power outlet. Make sure the voltage of the power supply meets the requirement of the input voltage. ­ 14 ­ 3 INSTALLING THE SWITCH Before installing the switch, verify that you have all the items listed under "Package Contents. " If any of the items are missing or damaged, contact your local SMC distributor. Also be sure you have all the necessary tools and cabling before installing the switch. PACKAGE CONTENTS The following contents should be found in your package: One SMCFS2601 Switch One power cord This User Guide Rackmount Kit Four rubber foot pads SMC Warranty Card ­ 15 ­ CHAPTER 3 | Installing the Switch Precautions PRECAUTIONS To ensure long-term and stable performance of the switch, pay attention to the following before installation. SAFETY REQUIREMENTS Before cleaning the switch, disconnect the power supply. Do not clean the switch using a wet cloth, and never use any other liquid for cleaning. Take waterproof measures during storage, transportation and operation of the equipment. Use only the power cord provided with the switch. Make sure the voltage of the power supply meets the requirement of the input voltage of the switch. Do not push any objects into the openings of the switch. Ensure the vent holes are well ventilated and unblocked. Do not open or remove the cover of the switch. LOCATION REQUIREMENTS When you choose a location for the switch, follow these guidelines: Install the switch on a flat and stable surface that can support the entire weight of the switch with all fittings. [. . . ] See "Powering On" on page 19. POWERING ON The SMCFS2601 switch is powered by connecting to an AC power supply using a power cord. However, if the unit powers off after running for a while, check for loose power connections, power losses or surges at the power outlet. If you still cannot isolate the problem, the internal power supply may be defective. ­ 21 ­ Installation APPENDIX A | Troubleshooting INSTALLATION Verify that all system components have been properly installed. [. . . ]