User manual SMEG 3LBS931

[. . . ] It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking. 1 12345- 2 34 567 8 9 67- 89- Motor OFF button ON button and motor speed selection button 1 - 2 - 3 - 1 - 2 . . . . Speed 1 LED Speed 2 LED and metal grease filter saturation LED (in this latter case, the LED will flash - See instructions on grease filter cleaning). Speed 3 LED and active carbon filter saturation LED (in this latter case, the LED will flash - See instructions on active carbon filter replacement). The active carbon filter saturation LED is not activated. [. . . ] Initially, only LED 4 will flash, then after the 3 seconds have passed, LED 5 (see page 13) will also start flashing, indicating that the active carbon filter saturation control system is active. To switch off the system, re-press the same two buttons: after 3 seconds LED 5 (see page 13) will stop flashing and the device will be switched off. Intensive speed LED Intensive speed ON switch This speed should be used when the concentration of cooking fumes or odours is particularly strong (for example when frying, cooking fish etc. ). The fast speed will run for about 5 minutes and then return to the speed previously set automatically (1, 2 or 3), or switch off if no speed was selected. To turn off the fast speed, before the end of the 5 minutes, press button 1 or button 2 (see page 13). OFF lamp button ON lamp button If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. Then plug it in again and try once more before contacting the Technical Assistance Service. Slider switches panel Two are the switches: one for lighting ON and OFF the lamps; one for lighting ON and selecting motor speed. Cleaning The cooker hood should be cleaned regularly internally and externally. For cleaning use a cloth moistened with denatured alcohol or neutral liquid detergents. Failure to carry out the basic standards of the cleaning of the cooker hood and replacement of the filters may cause fire risks. 10 Consult the designs in the front pages referenced in the text by alphabet letters. This must be done after approximately 160 hours of use. Once you have replaced the carbon filter, press button 1 (see page 10) for about 3 seconds until you hear the acoustic signal (beep). The LED 5 (see page 10) will now stop flashing. Mounting and replacing the active carbon filter: a) Disconnect the hood from the electricity. b) Remove the metal grease filters (Fig. c) If the active carbon filters have not been installed, place one active carbon filter on each side so that they cover the grates 11 e) Replacing lightbulbs a) Disconnect the hood from the electricity. b) Open the lamp compartment, proceeding according to the model in your possession: unscrew the lamp cover (fig. 3. 1) or extract the cover by levering it off with a small screwdriver or similar tool (fig. 3. 2) or Press on the lamp cover and release to open the cover (fig. c) Replace the damaged lamp with a new halogen lamp of 20Watt max. d) Refit the the metal grease filters and the light shield. [. . . ] d) Refit the the metal grease filters and the light shield. e) Before calling for repair service because the hood fails to light up, make sure the bulbs are screwed in tightly. Caution This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the appliance. [. . . ]