User manual SMEG 3LNS911

[. . . ] These shall be carefully followed at all times. NOTE: IF INSTALLING YOUR OVEN IN CANADA PLEASE CHECK TO MAKE SURE THAT YOU HAVE A MODEL WITH THE US AND CANADIAN LISTING POWER REQUIREMENTS The oven must be supplied with the proper voltage and frequency. The oven is manufactured to be connected to a three-wire or four-wire, single phase, 120/240 Volt, 60 Hz AC electrical supply on a sepa rate circuit fused on both sides of the line. If a 120/208 Volt circuit must be used, see Connecting to 120/208 Volt Circuit, in this manual. [. . . ] The oven support surface must be a minimum 3/4" (2cm) thick plywood platform. For single ovens, it must support 202 pounds. For double ovens, it must support 379 pounds. The platform must be solid, level and flush with the bottom of the cabinet cut out. Use extreme caution when moving or installing the oven. DO NOT LIFT THE OVEN BY THE DOOR HANDLE, remove the door for easier handling and installing. See REMOVING THE DOOR in the maintenance section of the Use Care Manual. Be very careful when moving or installing the oven to avoid damage to the oven frame or damage to the cabinets. An oven that is not level may provide poor or inconsistent baking results. DO NOT pinch the conduit between the oven back. WARNING Before installing or removing, turn power OFF at the service panel. Lock service panel to prevent power from being turned ON accidentally. Before making connections make sure the power is off and read and observe the following: 1. A separate three-wire or four-wire, single phase, 240 Volt, 60 Hz or 208 Volt, 60 Hz branch circuit is required for the oven. The oven must be connected with Copper or Aluminum wire. In the United States: Wiring must conform to the National Electrical Code, ANSI/NFPA No. You can obtain a copy of the National Electrical Code by writing to: National Fire Protection Association Batterymarch Park Quincy, MA 02269 In Canada: Wiring must conform to Cana dian Electrical Code C22. 1- latest edition. You can obtain a copy of the Canadian Electrical Code by writing to: Canadian Standards Association 178 Rexdale Boulevard Rexdale (Toronto), Ontario, Canada M9W 1R3 4. Wire size (Copper or Aluminum wire) and connections must be suitable for the rating of the appliance as per the National Electrical Code requirements. The flexible armoured cable extending from the oven should be connected directly to the junction box. The junction box should be located so as to allow as much slack as possible between the junction box and the oven so it can be moved if servicing is ever required. listed conduit connector must be provided at each end of the power supply cable. The voltage setting is stored and kept even after a long power-off. WARNING ELECTRICAL SHOCK HAZARD The electrical power to the oven branch circuit must be shut off while line connections are being made. Do not use an extension cord with this appliance. [. . . ] This appliance is manufactured with a green GROUND wire connected to the oven chassis. After making sure that the power has been turned off, connect the flexible conduit from the oven to the junction box using a U. L. Figures A and B and the instructions provided below present the most common way of connecting the ovens. Your local codes and ordinances, of course, take precedence over these instructions. [. . . ]