User manual SMEG 7520X ISTRUZIONI VARIE

[. . . ] Operation: The control panel is situated on the front right Caution!In some models the rear hole duct is not easily of the cooker hood and is equipped with various suction accessible, even when the tap (if mounted) is removed, in speeds. Use the highest speed for situations of high level this case remove the plastic piece E1 or E2 that is blocking vapour concentration in cooking. [. . . ] Always open the vapour the hole duct, by unwinding using pliers and cutter. Check collector N (Some models have an adjustable to the right that the filter/suction selector (inside the cooker hood) G or left O button). It is advisable to switch on the suction at is in the suction (A) position. In the case where it is not least 5 minutes prior to cooking and leave it in operation for possible to discharge the cooking fumes externally, the 15 minutes approximately after cooking is terminated. cooker hood may be used in the filter version by fixing a carbon filter, the fumes and vapours are recycled via the Maintenance anterior grill placed above the control panel. Check that the Prior to any maintenance work disconnect the cooker suction/filter selector is in the filter (F) position. The models provided without suction motor may function Grease Filter ­ may be one of the following types: only in the suction version and must be connected to a Paper filter must be replaced once a month or if coloured peripheral suction unit (not supplied). The suctioned air must not be conveyed in the same channel used for fumes discharged by appliances powered by other than electricity. The environment must always be adequately aerated when the cooker hood and other appliances powered by other than electricity are used at the same time. Flambé cooking with a cooker hood is prohibited. The use of a free flame is damaging to the filters and may cause fire accidents, therefore free flame cooking must be Carbon Filter (only for filter versions) The active carbon filter is not washable nor regenerative. The active carbon filter traps unpleasant cooking odours. Mounted inside the cooker hood covering the motor protector grill ­ it may be one of the following types: Rectangular S1 or S2: to be replaced every 6 months Affixing: insert the rear side T and hook further to the front (U). Circular (V-various models): to be replaced every 4 months. [. . . ] Mounted inside the cooker hood covering the motor protector grill ­ it may be one of the following types: Rectangular S1 or S2: to be replaced every 6 months Affixing: insert the rear side T and hook further to the front (U). Circular (V-various models): to be replaced every 4 months. Bayonet mount position the filter in the middle of the motor protection grill covering ensuring that the reference to X1 or X2 or X3 on the carbon filter match the Y1 or Y2 references on the conveyor, then turn clockwise; in case of dismounting turn anticlockwise, if provided with a Z tape remember to gently lift first. [. . . ]