User manual SMEG 85028

[. . . ] 2. 2 - Before connecting to the mains supply ensure that the mains voltage corresponds with the voltage on the rating plate inside the hood. 2. 3 - Connect the cooker hood to the mains via a bipolar switch which has 3mm clearance between the contacts. 2. 5 - When installed, the hood must be positioned at least 65 cm above the hotplate. 2. 6 - Never do flamb cooking under this cooker hood. [. . . ] 3 - Dismantle the ducting support (version with grill or version with filters), pulling the two pommels A (fig. 1) simultaneously: a) Fixing frame with screws: Fix the fitted group to the hood or cupboard, using the self-threading screws (No. b) Rapid fixing with side supports: The device B is set up to deal with a panel thickness of from 15 mm to 30 mm. Insert the group into the opening until the two devices B connect. Lock the adjustment screw C until the fitted group adheres tightly to the surface (fig. 4 - Close the ducting support by pushing and connecting the two pommels A (fig. 3. 2 - Ducting or recirculation fitting 1 - Ducting fitting: a - The hood can be ducted to the outside using either a rigid or a flexible 100 or 120 mm duct to be fixed with suitable clamps, not provided (fig. b - If the hood is provided with the charcoal filters fitted, the filters should be removed (see par. 6. 2). 2 - Recirculation fitting: a - When used in the recirculation mode, the charcoal filters must be fitted into the cooker hood (see par. b - The air is recirculated into the kitchen through the opening located on the upper side of the cabinet or of the hood (fig. 3. 3 - Electrical connection and working test 1 - The safety measures 4. 2, 4. 3 and 4. 4. 2 - Replacement: a - Remove the ducting grill, referring to paragraph 3. 1. 3. b - Replace the active charcoal filter (fig. 6. 5 - Lighting 1 - This is provided by two 40 W lamps or by two 20 W haolgen lamps. If the lamps do not work, open the suction grille and check that they are properly fitted. If the lamps have burned out they must be replaced using others of equivalent voltage and power. 2 - Replacement: a) 40 W lamp (fig. 9), unscrew the burned out lamp and fit the new one. b) 20 W halogen lamp (fig. 10), extract the lamp by pulling gently. When replacing, ensure that the pins are correctly inserted into the lamp holders. 6. 6 - Cleaning When cleaning the hood: - Never use a wet cloth or sponge, or running water. - Never use thinners or products containing alcohol, as they might damage the paintwork. - Never use abrasive cleaning materials, in particular when cleaning stainless steel surfaces. [. . . ] en el producto o en su embalaje indica que este producto no se puede tratar como desperdicios normales del hogar. Este producto se debe El smbolo entregar al punto de recoleccin de equipos elctricos y electrnicos para reciclaje. Al asegurarse de que este producto se deseche correctamente, usted ayudar a evitar posibles consecuencias negativas para el ambiente y la salud pblica, lo cual podra ocurrir si este producto no se manipula de forma adecuada. Para obtener informacin ms detallada sobre el reciclaje de este producto, pngase en contacto con la administracin de su ciudad, con su servicio de desechos del hogar o con la tienda donde compr el producto. [. . . ]