User manual SMEG A11X-6

[. . . ] INSTRUCTIONS FOR SAFE AND PROPER USE________________ 4 INSTALLATION OF THE APPLIANCE_________________________ 6 ADAPTATION TO DIFFERENT TYPES OF GAS _______________ 11 FINAL OPERATIONS _____________________________________ 13 DESCRIPTION OF CONTROLS ____________________________ 15 USE OF THE COOKING HOB ______________________________ 21 USE OF THE OVEN ______________________________________ 23 AVAILABLE ACCESSORIES _______________________________ 24 COOKING HINTS ________________________________________ 25 CLEANING AND MAINTENANCE ___________________________ 29 EXTRAORDINARY MAINTENANCE _________________________ 32 THESE INSTRUCTIONS ARE VALID ONLY FOR END USER COUNTRIES WHOSE IDENTIFICATION SYMBOLS APPEAR ON THE COVER OF THIS MANUAL. INSTRUCTIONS FOR THE INSTALLER: these are for the qualified technician who must carry out a suitable check of the gas system, install the appliance, set it functioning and carry out an inspection test. INSTRUCTIONS FOR THE USER: these contain user advice, description of the commands and the correct procedures for cleaning and maintenance of the appliance. INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKER. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE COOKER. [. . . ] Once the desired duration is obtained, cooking will start about 5 seconds after the last pressure on or . The display will show the current time, represented by the constantly illuminated segments, and the minutes left to the end of the cooking time, represented by the flashing segments (each flashing segment means 12 minutes of cooking time left). At the end of the cooking time the timer will switch the oven heating elements off, the beeps will start to sound and the numbers on the dial will flash. The duration can also be reset by deleting the program selected: Press the central key for 2 seconds to cancel the set duration and the oven will have to be manually switched off. 1 - - 2 - - Warning: it is not possible to set cooking durations of more than 12 hours. 19 Instructions for the user Cooking start: as well as setting a cooking duration, the cooking start time can also be set (with a maximum delay of 12 hours in relation to the current time). To set the cooking start/end time, proceed as follows: Set the cooking duration as described in the previous point. Within 5 seconds of last pressing key or , press key again will flash on the display to set the cooking end time. Symbol together with the current time, with internal segments illuminated to and to set the show the end of cooking time. 5 seconds after the last key is pressed, the display will show the current time and the cooking start and end times, which will be represented by the illuminated inside segments. The display segments will be constantly illuminated as long as the current time is not the same as the cooking start time; as soon as the current time reaches the set starting time, all the inside segments will start to flash, indicating that the oven has started cooking. At the end of the cooking time the timer will switch the oven heating elements off, the beeps will start to sound and the numbers on the dial will flash. To delete the entire set program, hold down the central key for 2 seconds; if cooking has already started, the oven will have to be switched off manually. Here we can see a programming example: the current time is 7:06 and cooking is programmed to start at 8. 00 and end at 9. 00. At 8 o'clock the inside segments between 8 and 9 will start to flash, while the hours hand will 1 remain still. - - - Warning: for the oven to start cooking operations after the programming procedures just described, the thermostat and functions switch knob must be correctly set on the desired temperature and function. 5. 2. 4 Display brightness reduction To reduce the energy consumption in stand-by, key can be pressed to reduce the display brightness. To restore the normal brightness, press again. 20 Instructions for the user 6. USE OF THE COOKING HOB 6. 1 Lighting of the cooking hob burners Before lighting the hob burners check that the flame caps are in the correct position and that their burner caps are in place, making sure that the holes A in the flame caps correspond to the spark plugs and thermocouples. Grid B should be used with Chinese woks. Each knob corresponds to the burner indicated. The appliance is equipped with an electric lighting device. To light the burners, press and turn the knob anticlockwise to the large flame symbol . Keep the knob pressed for about 2 seconds to let the thermocouple heat up. If the burner turns off when the knob is released, it means that the thermocouple isn't hot enough. Repeat ignition and keep the knob pressed longer. Once the burner has been ignited, the flame can be regulated as required. [. . . ] Remove the side runners by lifting them at the front and extracting them from the hole at the back. · · DO NOT USE A STEAM JET FOR CLEANING THE INSIDE OF THE OVEN. Clean the oven grill and side guides with hot water and non-abrasive detergent. Rinse and dry. 30 Instructions for the user For easier cleaning, the storage drawer underneath the oven can be completely removed. Pull it right out and raise the front (as for an ordinary drawer). [. . . ]