User manual SMEG A1DB-6

[. . . ] All effective requirements of the respective electricity supply company must also be met. J To satisfy the relevant safety instructions, a plug and socket device or an all pole disconnector with a contact gap of at least 3 mm must be fitted on the installation side. [. . . ] If the appliance is connected via a plug and socket device, the plug must be accessible following installation of the appliance. J The appliance corresponds to Safety Class I and may be operated only in conjunction with a protective conductor terminal. J Safeguard via B or C miniature circuit breaker (formerly L or G in Germany). J The hob cannot be installed above an oven, a refrigerator, a dishwasher, or a build under washing machine. J In the event that an intermediate panel is present, the clearance to the lowest part of the hob must be at least 5 mm. Where the cutout is positioned over the side panel of a kitchen unit, the side panel must be lowered by cutting out a piece at least 25 mm in width to allow the hob to sink into position. To prevent swelling due to dampness, seal the lateral cut edges with silicone rubber, heat resistant lacquer or cast resin. J See rating plate for voltage. J The mains connection cable is con nected to the under side of the appliance. Remove sealing strips from the protective foil and lay them around the cutout. Make sure that the ends of the strips meet, leaving no spaces. [. . . ] Make sure that the ends of the strips meet, leaving no spaces. Connect a prescribed plug to the cable, or connect the cable directly to a connector box. [. . . ]