User manual SMEG A1DNA-7

[. . . ] BEFORE INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . USING THE HOB . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . CLEANING AND MAINTENANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . INSTALLING THE APPLIANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The inside of the appliance should be cleaned to remove all manufacturing residues. For further information, see point "6. When the electric plates or barbecue (when fitted) are used for the first time, they should be heated to the maximum temperature for long enough to burn off any oily residues left by the manufacturing process, which might contaminate foods with unpleasant smells. 7 Instructions for the User 6. USING THE HOB 6. 1 Gas hob Before lighting the hob burners check that the flame diffuser rings are correctly in place with their respective burner caps, making sure that the holes A in the flame diffusers are aligned with the plugs and thermocouples. The optional grid B is for use with woks. To prevent damage to the hob, the appliance comes complete with a raised grid C. This grid is intended for use underneath pans which exceed the diameter stated in the table in point "6. 3 Pan diameters". All pans more than 30 cm in diameter must only be used on the central burner. The burner it controls is shown next to each knob. The appliance is equipped with an electronic ignition device. Simply press the knob and turn it anticlockwise to the maximum flame symbol, until the burner lights. If it does not light within the first 15 seconds, turn the knob to 0 and wait at least 60 seconds before trying to light the burner again. INSTALLING THE APPLIANCE 8. 1 Fitting the appliance in the top This appliance is in class 3. The procedures required below must be carried out by a skilled builder and/or joiner. The hob can be installed on various materials, including masonry, metal, solid wood and wood finished with plastic laminates, provided the material is heat-resistant (T 90° C). Create an opening with the dimensions shown in the figure in the work surface, observing a minimum distance of 50 mm from the rear edge. The lower part of the protective cover must be fully accessible when the appliance is installed. This appliance can be installed next to walls that are higher than the work surface, as long as the distance "X" is kept, as shown in the figure, to avoid damage from overheating. Make sure that there is at least 750 mm between the hob burners and any shelving placed vertically above them. This type of appliance also requires a cut 3 mm deep in the top with the dimensions shown in figure 2 (detail A). The right section is indicated for laminated tops whose thickness is below 3 mm. 2) 11 Instructions for the Installer The entire surface of the cut (fig. Now place the 7 brackets supplied to secure the top to the supporting structure. The figures below show how to use these brackets. The L shaped square as per B in fig. 2 must be fixed to the sides of the work top. After having fixed the hob it is necessary to fix better the shorter sides of the appliance using the screws that are supplied. [. . . ] To check the operating pressure of the appliance it is recommended at least 2 large size burners are used. Ensure appliance is secured to wall when installation is completed. The regulator supplied must be fitted to the ½ BSP thread at the rear of the appliance. An approved manual shut-off valve must be installed. [. . . ]