User manual SMEG A2D-5

[. . . ] Recommendations are given for the correct use of the baskets, spray arms, containers, filters, washing programs, and for operating the controls. Following the cleaning instructions provided here will keep your dishwasher's performance at peak levels in the long term. This user-friendly manual will provide answers to all your questions about use of the dishwasher. INSTALLATION INSTRUCTIONS: these are intended for the qualified technician who must carry out the installation, hook-up and testing of the appliance. USER INSTRUCTIONS: these consist of recommendations for using the appliance, a description of its controls and of the correct cleaning and maintenance procedures. 1 Safety instructions 1. [. . . ] For further information, refer to the detergent pack. IMPORTANT: when no longer required, the option must be deactivated by pressing the relative button (the light goes out). These products are not suitable for use with excessively “hard” water. If the hardness level set is higher than H3, when the option is activated the relative light flashes to indicate that the product is being used incorrectly; the dishwasher will still work, but washing results may be poor. 15 User instructions ULTRA CLEAN Prolongs the final hot rinse to ensure a further reduction in the bacteria level. If the temperature in the tank falls during this stage of the program (e. g. because the door is opened or due to a power cut), the option light an program lights (2) flash to warn that this additional wash phase has not been completed successfully. This does not mean that the wash program has been less effective than usual. PROGRAM DELAY The start of the washing program can be delayed by from 1 to 24 hours depending on the model, to program the dishwasher to operate at the preferred time of day (e. g. ● It is not possible to select the option once the cycle has begun. ● When the door is closed, the appliance will prewash the dishes, after which the count of the "program delay" set will begin. Models without display The start of the program can be delayed by 3, 6 or 9 hours. The salt container can hold approximately 1. 7 kg of salt grains. Some models are equipped with a cap with a no-salt optical indicator containing a green float which descends as the salt concentration in the water drops. When the green float can no longer be seen through the transparent cap, salt must be added. The container is situated at the bottom of the dishwasher. After removing the lower basket, unscrew the salt container cap by turning it anticlockwise and pour in the salt using the funnel supplied. Before replacing the cap, remove any salt residues from around the opening. • • When using the dishwasher for the first time, in addition to the salt it is also necessary to add one litre of water to the container. Each time the salt container is refilled, make sure that the cap is securely closed. The mixture of water and detergent must never enter the salt container, as this would compromise the operation of the regeneration system. In the event of this occurring, the warranty will be invalidated. Only use salt specially formulated for domestic dishwashers. [. . . ] Troubleshooting The dishwasher is capable of signalling a number of faults by the simultaneous illumination of multiple indicator lights; the meanings are given below: FAULT DESCRIPTION Aquastop failure The anti-flooding system has activated (relevant models only). The system trips in case of water leaks. Safety level The system which limits the water level inside the dishwasher has tripped. Interrupt the program and switch off the dishwasher. [. . . ]