User manual SMEG A42A-5

[. . . ] INSTRUCTIONS FOR SAFE AND PROPER USE _____________________ 33 INSTALLATION OF THE APPLIANCE ______________________________ 35 ADAPTATION TO DIFFERENT TYPES OF GAS______________________ 38 FINAL OPERATIONS ___________________________________________ 40 DESCRIPTION OF CONTROLS___________________________________ 41 USE OF THE COOKING HOB ____________________________________ 47 USE OF THE OVENS ___________________________________________ 48 AVAILABLE ACCESSORIES _____________________________________ 49 COOKING HINTS ______________________________________________ 50 CLEANING AND MAINTENANCE _________________________________ 55 EXTRAORDINARY MAINTENANCE _______________________________ 58 THESE INSTRUCTIONS ARE VALID ONLY FOR END USER COUNTRIES WHOSE IDENTIFICATION SYMBOLS APPEAR ON THE COVER OF THIS MANUAL. INSTRUCTIONS FOR THE INSTALLER: these are for the qualified technician who must carry out a suitable check of the gas system, install the appliance, set it functioning and carry out an inspection test. INSTRUCTIONS FOR THE USER: these contain user advice, description of the commands and the correct procedures for cleaning and maintenance of the appliance. 32 Introduction 1. INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKER. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE COOKER. [. . . ] 6/7 seconds after the last time a key is pressed, the display will show the current time and the cooking start and end times, indicated by the illuminated inside segments. The segments on the display will be constantly on until the current time is the same as the cooking start time; as soon as the current time reaches the cooking start time set, all the inside segments will start to flash, indicating that the oven has started cooking. When the end of the cooking time is reached, the timer will switch off the oven heating elements, the beeps will start and the numbers on the dial will flash. To reset the entire program set, keep the central key pressed for 1 or 2 seconds: if cooking has already started the oven will have to be switched off by hand. The image on the right shows an example of programming: the current time is 7. 06 and cooking is programmed to start at 8 o'clock and finish at 9. At 8 o'clock, the inside segments between 8 and 9 will start to flash and the hour pointer will remain still. Caution: for the oven to start cooking after the programming procedure just described, the thermostat and function selector must be properly set on the temperature and function required. 5. 2. 4 "DEMO" Function Models with analogue/digital programmer feature a "DEMO" function which deactivates the heating elements while leaving the other functions unchanged. To activate it, simply press the , and keys for 3/4 seconds. A confirmation beep will inform the user that the function is active. To deactivate it, simply repeat the same procedure. - 46 Instructions for the user 6. USE OF THE COOKING HOB 6. 1 Lighting of the cooking hob burners Before lighting the hob burners check that the flame-spreader crowns are located in their housing with their respective caps. Ensure that flamespreader holes A correspond to the spark plugs and the thermocouples. Grid B should be used for Chinese wok type pans. Each knob corresponds to the burner indicated. The appliance is equipped with an electronic lighting device. Just press and turn the knob until the burner lights. anticlockwise to the maximum flame symbol Keep the knob pressed for about 2 seconds to let the thermocouple heat up. If the burner turns off when the knob is released, it means that the thermocouple isn't hot enough. Repeat ignition and keep the knob pressed longer. Should the burners go out by accident a safety device intervenes to block gas supply even with the tap open. 47 Instructions for the user 6. 2 Practical advice for using the cooking hob burners For better use of the burners and lower gas consumption, use covered containers that are proportional in size to the burner to prevent the flame from licking the sides (see paragraph "6. 3 Diameter of containers"). When water reaches the boiling point, lower the flame so that it doesn't overflow. To avoid burns or damage to the hob, all recipients or griddle plates must be placed within the perimeter of the cooking hob. [. . . ] Check them frequently and clean them with a wet rag if necessary. Any dry residue should be removed with a toothpick or a needle. 10. 3 Cleaning the inside of the oven For best oven upkeep clean regularly after having allowed to cool. Clean the oven grill and side guides with hot water and non-abrasive detergent. 10. 3. 1 Self-cleaning liners The main oven is equipped with continuous self-cleaning enamelled liners. [. . . ]