User manual SMEG ABM50

[. . . ] 20 6. 1 Changing the inside light bulb . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 INSTRUCTIONS FOR THE INSTALLER: these are intended for the qualified engineer who is to install, commission and test the appliance IINSTRUCTIONS FOR THE USER: these provide recommendations for use, a description of the controls and the correct procedures for cleaning and maintaining the appliance 12 The environment - Disposal instructions 1. THE ENVIRONMENT - DISPOSAL INSTRUCTIONS OUR REFRIGERATORS ARE ONLY PACKAGED USING NON-POLLUTANT, ENVIRONMENTFRIENDLY, RECYCLABLE MATERIALS. WE URGE YOU TO COOPERATE BY DISPOSING OF THE PACKAGING PROPERLY. [. . . ] The manufacturer declines all responsibility for injury or damage caused by failure to comply with the above regulations or deriving from tampering with even just one part of the appliance and the use of non-original spare parts. 14 Safety Precautions 3. SAFETY PRECAUTIONS INSTRUCTIONS FOR THE INSTALLER: THESE ARE INTENDED FOR THE QUALIFIED ENGINEER WHO IS TO INSTALL, COMMISSION AND TEST THE APPLIANCE. THE APPLIANCE MUST BE INSTALLED BY QUALIFIED STAFF TO PREVENT DAMAGE OR INJURY. THE REFRIGERANT IN THE APPLIANCE'S CIRCUIT CONTAINS NH3 (AMMONIUM) AND IS TOXIC AND FLAMMABLE: TAKE CARE NOT TO DAMAGE THE REFRIGERATION CIRCUIT. IF LEAKS OCCUR, VENTILATE THE PREMISES IMMEDIATELY. THE REFRIGERANT IS ALSO HARMFUL TO THE EYES. TAKE GREAT CARE IN CASE OF LEAKS FROM THE REFRIGERATION CIRCUIT. IN CASE OF A REFRIGERANT SPILL, ELIMINATE ALL POSSIBLE CAUSES OF SPARKS OR NAKED LIGHTS IN THE VICINITY OF THE APPLIANCE, DISCONNECT THE PLUG FROM ITS SOCKET AND VENTILATE THE ROOM. NEVER ATTEMPT TO MOVE THE APPLIANCE BY PULLING ON THE DOOR OR THE HANDLE. TAKE CARE THAT THE DOOR DOES NOT CLOSE AGAIN, TRAPPING YOUR FINGERS. ON INSTALLATION, IF ANY MANUFACTURING DEFECTS OR DAMAGE CAUSED IN TRANSIT ARE NOTED, CALL YOUR NEAREST SERVICE CENTRE AT ONCE. FOR INSTALLATION AND CONNECTION, FOLLOW THE INSTRUCTIONS PROVIDED IN THIS MANUAL ONLY. IN CASE OF MALFUNCTIONS, DISCONNECT THE APPLIANCE FROM THE POWER SUPPLY BY REMOVING THE PLUG, WITHOUT PULLING ON THE POWER SUPPLY LEAD. THE POWER SUPPLY SOCKET MUST BE ACCESSIBLE EVEN AFTER THE APPLIANCE HAS BEEN INSTALLED. ALL REPAIRS OR OTHER WORK NOT COVERED BY THIS MANUAL MUST BE CARRIED OUT BY A QUALIFIED ENGINEER, TO BE FOUND AT AN AUTHORISED SERVICE CENTRE. NEVER ATTEMPT TO REPAIR THE APPLIANCE YOURSELF. NEVER STORE SPRAY CANS CONTAINING FLAMMABLE GASES INSIDE THE APPLIANCE. ANY LEAKS MAY CONSTITUTE A SERIOUS THREAT TO USERS' SAFETY. HIGH-PROOF ALCOHOLIC BEVERAGES MUST ALWAYS BE STORED UPRIGHT AND MUST BE WELL SEALED. THE USE OF ELECTRICAL APPLIANCES (SUCH AS ICE-CREAM MAKERS OR WHISKS) INSIDE THE APPLIANCE IS FORBIDDEN. NEVER USE THE APPLIANCE OR ANY PART OF IT AS A STAND OR STEPS. THE APPLIANCE IS INTENDED FOR USE BY ADULTS. [. . . ] USING THE MINIBAR To switch the refrigerator on, turn the knob of the thermostat in the bottom left-hand corner inside the appliance. When the knob is turned to 0, the appliance is switched off. The operating settings are from MIN (highest inside temperature) to MAX (lowest inside temperature). Only use the highest setting (MAX) if absolutely necessary: in some conditions, the refrigeration unit might operate continuously, causing excessive ice formation, leading to higher electricity consumption. [. . . ]