User manual SMEG ALFA30F

[. . . ] SUITABLE HEATPROOF GLOVES SHOULD BE WORN FOR ALL OPERATIONS. THE I. D. PLATE WITH TECHNICAL DATA, REGISTRATION NUMBER AND BRAND NAME IS LOCATED IN AN EXPOSED POSITION AT THE REAR OF THE OVEN. THE USE OF THIS APPLIANCE IS NOT PERMITTED TO PEOPLE (INCLUDING CHILDREN) OF REDUCED PHYSICAL AND MENTAL ABILITY, OR LACKING IN EXPERIENCE IN THE USE OF ELECTRICAL APPLIANCES, UNLESS THEY ARE SUPERVISED OR INSTRUCTED BY ADULTS OR PEOPLE RESPONSIBLE FOR THEIR SAFETY. BEFORE USE, THE OVEN DISHES MUST BE WASHED WITH A SUITABLE DISHWASHING DETERGENT (DO NOT USE ABRASIVE PRODUCTS). THE OVEN DIMENSIONS ARE DESIGNED FOR A MAXIMUM LOAD OF 7 KG. BEFORE THE APPLIANCE IS PUT INTO OPERATION, ALL THE LABELS AND PROTECTIVE FILMS APPLIED INSIDE OR OUTSIDE MUST BE REMOVED. THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE 2002/96/EC ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE). [. . . ] In case of permanent connection, ensure that power cable is equipped with an easily accessible omnipolar switch fitted in proximity to the apparatus and with a gap between contacts equal to or greater than 3 mm. 23 Instructions for the installer 2. 1. 1 Safety thermostat The oven is fitted with a safety device which trips in case of serious malfunction. To reset, contact the nearest servicing centre. The manufacturer declines all responsibility for damage to persons or things caused by non-observance of the above prescriptions or by interference with any part of the oven. 2. 2 Levelling Adjust the four feet so as to set the oven on a perfectly level plane. For this purpose, loosen the lock nut and unscrew the foot. The range of adjustment of the screw is 10 mm. 2. 3 Steam exhaust pipe An exhaust pipe is fitted on the back of the oven to allow the discharge of steam during cooking. Make sure that it's no way obstructed and take care do not crush it. 24 Instructions for the user 3. DESCRIPTION OF CONTROLS All oven knobs and controls are located on the side panels. TIMER KNOB This permits to select manual or timer-controlled cooking with automatic turning off of the oven at end of the cooking cycle. To set to manual, turn the knob anticlockwise to . To set cooking time, turn the knob clockwise. Adjustment is progressive so that time can also be set to any intermediate value. Upon completion of the cooking cycle, the knob automatically returns to 0, the oven turns off and a buzzer signal is set off, which switches off automatically after 20 seconds. Do not use metallic sponges or sharp scrapers: they will damage the surface. Use normal non-abrasive products for steel, and a wooden or plastic tool if necessary. Rinse thoroughly and dry with a soft cloth or deerskin. 28 Instructions for the user 5. 2 Cleaning the inside of the oven To maintain the oven in perfect condition, clean it regularly at the end of the work day. Remove the side guides by lifting them up from the front; slide them out of the rear hole and take off. · Clean oven grill and side guides with warm water and non-abrasive detergents. Rinse and dry. 5. 3 Door glass The door glass should always be kept clean. In case of tough spots, clean with a damp sponge using regular detergent. 29 Instructions for the user 6. EXTRAORDINARY MAINTENANCE The oven may require extraordinary maintenance or replacement of parts subject to wear such as seals, bulbs, and so on. The following instructions describe how to carry out these minor maintenance operations. Before any intervention, disconnect the power supply of the oven. 6. 1 Replacing the light bulb Remove protection cover A using a screwdriver to pry open. Remount protection cover A. Use only oven light bulbs (suitable for a temperature of up to 300°C). 6. 2 Removing the door Open the door completely and insert the pins (supplied) into the holes from the inside. Close the door to an angle of about 45° and lift it off. [. . . ] For manual control of the cooking time, turn the knob to the symbol . To set the cooking time, turn the knob clockwise. The numbers 5 to 60 correspond to minutes. The regulation of the time is progressive and all of the positions between the figures indicated can be used as settings. [. . . ]