User manual SMEG ALFA41XEN

[. . . ] THE APPLIANCE MUST BE CONNECTED TO EARTH IN COMPLIANCE WITH ELECTRICAL SYSTEM SAFETY REGULATIONS. IF THE MAIN ELECTRICAL CONNECTION IS TO BE MADE BY MEANS OF A PLUG AND SOCKET, THEY MUST BOTH BE OF THE SAME TYPE AND MUST BE CONNECTED TO THE POWER SUPPLY LEAD IN ACCORDANCE WITH THE RELEVANT REGULATIONS. NEVER DISCONNECT THE PLUG BY PULLING ON THE CABLE. NEVER OBSTRUCT THE OPENINGS PROVIDED FOR VENTILATION OR HEAT DISPERSAL. IMMEDIATELY AFTER INSTALLATION, CARRY OUT A QUICK TEST ON THE OVEN FOLLOWING THE INSTRUCTIONS PROVIDED LATER IN THIS MANUAL. IF THE APPLIANCE FAILS TO OPERATE, DISCONNECT IT FROM THE ELECTRICAL MAINS AND CONTACT YOUR NEAREST SERVICE CENTRE. [. . . ] Press START to confirm the start of the program. The program starts, performing the preheating stage; the display shows "PrEh". When the preheating is complete, a "BEEP" sounds to indicate that cooking can start. (If START is not pressed after the beep, the temperature is held constant for about 10 minutes, after which it will start to drop for a period up to a maximum time of 20 minutes, counted from when the beep sounded. During this stage, the display shows the parameters of the selected program). ­ although this is not recommended in terms of cooking quality, the program can be started even before the preheating temperature is reached by pressing START. During cooking, the display shows the time left until the end of the cooking process and the temperature set. During the last minute of cooking, the display will only show the countdown from 60 to zero seconds (end of cooking time). When all the cooking time has passed, a BEEP will sound for 20 seconds and the display will show "End". During these 20 seconds the user can extend the cooking time as required, in manual mode, as follows. Press START; the display will show "tp00". From now on, each pressure on the START key corresponds to one more minute's cooking; up to 10 extra minutes are permitted. Cooking will restart at the programmed temperature after 5 seconds. After these additional minutes, the program repeats the cooking end procedure described above and after the 20-second BEEP the word "End" will flash for 20 minutes, during which time the temperature will gradually fall, stabilising at 100°C. After 20 minutes, the oven switches off. 4. 5 Manual mode cooking Use the knob to select the "easy" program ( *). The special feature of this user-editable program is that the cooking parameters set are not retained in the memory when the knob is turned to any other position. This means that an "empty" program is always immediately available for quick, easy editing. 4. 5. 1 How to use this program Use the knob to select the "easy" program ( *). 27 Instructions for the User The display shows "- - - - " to indicate that there are no cooking parameters present. Press START or keep it pressed to increase the preheating temperature; each time START is pressed the temperature increments by 5°C (from 30° to 300°). Press STOP to increase the number of minutes of cooking (N. B. if a cooking time of 99 minutes is set, the cooking time will be infinite, meaning that cooking can only be stopped in manual mode, by ending the program). Release STOP and preheating will start automatically after 5 seconds. [. . . ] Replace the bulb B with another of the same type. Replace the protective cover A. Use only light bulbs approved for ovens (T 300 °C). 33 Instructions for the User 6. 2 Removing the door Hinges with mobile riders Take hold of the two sides of the door with both hands close to the hinges C and lift the levers D. Raise the door to an angle of about 45° and remove it. To reassemble, fit the hinges C into their grooves, then lower the door into place and engage the levers D. Hinges with mobile levers Completely open the door and take hold of it on both sides close to the hinges. [. . . ]