User manual SMEG ALVIKA/20

[. . . ] 33 USING THE OVEN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35 CLEANING AND MAINTENANCE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43 EXTRAORDINARY MAINTENANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45 OVEN INSTALLATION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] USING THE OVEN THE OVEN IS DESIGNED FOR A MAXIMUM LOAD OF 3. 5 KG. 5. 1 · General warnings and advice When using the oven for the first time, heat it up to its maximum temperature for a duration long enough to burn off any oily residues from the manufacturing process. To access food during cooking, always leave the door open as short a time as possible to prevent the temperature in the oven from falling and ruining the food. · 5. 2 Setting the power When connecting the oven for the first time, the maximum power absorbed will appear flashing on the display. If the product is already connected, this will be in the "OFF" status. In both cases proceed as follows: · Press the "PUSH" knob for at least 3 seconds: the display will show the text "P8. 3" (equivalent to the maximum absorbed power of 8. 3 kW) if the oven connection is three phase, or "P5. 5" (equivalent to the maximum absorbed power of 5. 5 kW) if the oven connection is single phase. · Turn the knob to the or symbols to move between the proposed power absorptions P8. 3, P5. 5 and P3. 0 (if the oven connection is three phase), or P5. 5 and P3. 0 (if the oven connection is single phase). Once you have selected the power, press the "PUSH" knob to confirm the selection. · The power setting operation must be performed the first time that the oven is connected. The value set is stored and used automatically whenever the oven is used subsequently. 35 Instructions for the user 5. 3 Choice of programs This appliance allows you to select 40 cooking programs including: · 38 programs that can be edited and saved as the user wishes; · 1 preheating program with delayed start "P39"; · 1 manual program "P40". 5. 4 Humidified cooking (on some models only) The humidified programs that the user can modify are included between P01 and P40 apart from program P39. 3 different humidity levels can be set for each program: H1 (low), H2 (medium) and H3 (high). Each set level has different intervals between the steam injection cycles: 8' pause for H1, 5' for H2 and 2' for H3. Humidification cycles can be set and modified only if an oven temperature higher than 110°C is selected. The oven chamber can be humidified during cooking by controlling the relevant inlet valve: To do this, just keep the "START" button pressed for at least one second. During cooking, if it is necessary to open the oven door, the display shows the message "door" together with a continuous acoustic signal. When the door is closed the oven will continue cooking. 39 Instructions for the user 5. 6. 3 Extending a cooking operation When a cooking operation finishes, it is possible to extend it manually: 1 While the display is showing the text "End", press the "START" button; the text "tP00" will appear on the display. Turn the knob to the or symbols to set the additional minutes of cooking; at most 20 extra minutes are allowed. 3 To start cooking with the extra time that has just been set, press the "START" button for at least 2 seconds. 4 At the end of cooking, the text "End" will continue to flash for the next 20 minutes and the oven light will remain on. When cooking needs to be extended, the oven is set to carry out only thermoventilated cooking. If more grilling is required, the program must be modified manually during the cooking cycle (see paragraph "5. 6. 4 Modifying a program during cooking"). 5. 6. 4 Modifying a program during cooking The program can be modified during cooking: 1 Press the "PUSH" knob: the display will show the cooking temperature. 2 Modify the settings as described in points 3 - 12 of paragraph "5. 5. 1 Programs with thermoventilated function". Changes made to the program during cooking are not saved. 2 3 3 seconds after the last change, the program automatically quits the modification status and saves the settings (as described in this paragraph, the modified parameters are saved solely until the end of cooking). 40 Instructions for the user 5. 7 Manual cooking The manual program is "P40" and can be edited by the user, but does not save the cooking parameters set in memory. [. . . ] Before removing the seal, take off the oven door as described above. Once the door has been taken off, lift the tabs at the corners as shown in the figure. 47 Instructions for the installer 8. OVEN INSTALLATION The oven must be installed on a free-standing horizontal work top. The distance from the rear wall must allow easy access to the terminal board for connection of the power supply cable. [. . . ]