User manual SMEG B70MFX5

[. . . ] This is important, as otherwise the plastic part could damage the washing machine during operation. Open the lid by pressing it slightly down while raising the handle. Remove the polystyrene cushion (depending on model). Remove the blue protective film from the panel (depending on model). [. . . ] The key symbol on the display disappears and the programme can be started. Appliance stops during the · "Rinse hold" option is activated (if available on your model) and programme, and the (Rinse hold) lights up in the programme sequence indicator "Start/Pause" light flashes terminate "Rinse hold" by pressing "Start/Pause" or by choosing and starting "Drain". · Programme has been changed - reselect desired programme and press "Start/Pause". · Programme has been interrupted and eventually lid has been opened close lid and restart programme by pressing "Start/Pause". · The appliance's safety system has been activated (see "Description of red indications"). · Water tap is not opened or water inlet hose is kinked ("Water tap closed" indication lights up). Detergent dispenser · Detergent dispenser is not properly installed, or detergent dispenser is contains residues from blocked (see "Care and Maintenance"). detergent/additives at end · Filter in the water inlet hose is blocked (see "Care and Maintenance"). of wash Appliance vibrates during · Washing machine is not level; the feet are not properly adjusted (see spin cycle "Installation"). · The transport bracket has not been removed; before using the washing machine, the transport bracket must be removed. Final spin results are poor The appliance has an imbalance detection and correction system. If individual heavy items are loaded (e. g. Open lid and close drum flaps, then select and start desired programme again. If fault persists, notify our After-Sales Service. "Electrical module fault" Select and start "Drain" programme or push "Reset" button for at least 3 seconds. "Water level too high" (after programme cancellation or false operating). Switch off appliance and then switch it on again, select programme "Drain" and start within 15 sec. "Waterstop fault" Switch off appliance, pull out mains plug and turn water tap off. Tilt appliance forward carefully to allow collected water to flow out from the bottom. Then: · Plug in the appliance again. · Turn the water tap on (if water immediately flows into the appliance without the appliance being started, there is a failure; turn off the tap and notify After-Sales Service). · Select and start the desired programme again. "Overfoaming" Too much foam interrupted the wash programme. [. . . ] . . after having pressed the "Start/Pause" button: · Press the "Reset" button for at least 3 second. The start delay indicator light goes off. PROGRAMME START Open the tap and press the "Start/Pause" button. The indication lamp next to the "Start/Pause" button lights up. [. . . ]