User manual SMEG BQ90S

[. . . ] PRECAUTIONS FOR USE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26 DISPOSAL INSTRUCTIONS - OUR ENVIRONMENT POLICY. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 SAFETY PRECAUTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 INTENDED USE OF THE APPLIANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The hose must be fitted or replaced (check its expiration date periodically) in compliance with the relevant regulations. 34 Instructions for the Installer 7. 4 Burner, Nozzle and Gas Consumption Data Tables Burner Rated heat capacity (kW) Nozzle diameter 1/100 mm 100 100 100 94 Bottled gas ­ G30/G31 30/37 mbar By-pass 1/100 mm 85 85 85 65 Reduced heat capacity (W) 2200 2200 2200 1500 Capacity g/h G30 327 327 327 254 Capacity g/h G31 321 321 321 250 Left Central (BQ90S) Right Ultra-rapid (BQ6030S) 4. 5 4. 5 4. 5 3. 5 7. 5 Check for any gas leaks These procedures must be carried out the first time the barbecue is connected and whenever the gas supply is disconnected and reconnected. Once the barbecue hose has been connected to the gas supply (LPG), proceed as follows: 1 Open the gas valve on the LPG cylinder, BUT DO NOT ATTEMPT TO LIGHT THE BURNERS. 2 While there is gas pressure in the hose, check all the connections for leaks using a soap and water solution. Never look for leaks with a naked light. 3 If there are any leaks, bubbles will appear on the poor connection from which gas is escaping. 4 Turn off the cylinder gas tap, tighten the connection which was leaking and repeat the test. 5 If the gas leaks persist, contact your nearest supplier. NEVER CHECK FOR LEAKS WITH A NAKED LIGHT. 35 Instructions for the Installer 7. 6 Fixing the gas cylinder to the trolley (optional) To secure the gas cylinder to the trolley, use the chain provided, passing it through the points shown in the diagram. Fit one link of the chain over the pin A, then pass it over points B and C on the top of the cylinder, through the hole D and underneath the frame. Then bring the chain out of the frame in point E, fix it to the pin A again and tighten the ring-nut. If the pin which secures the chain has to be replaced, refer to the illustrations below which show how to fit and fix the pin. 1) 2) 7. 7 Hose clip There is a hose clip on the trolley. It must be used to prevent the hose from touching other surfaces in the section between the appliance's gas connection and the cylinder connection. The bottom of the carriage is able to take gas cylinders up to 50 cm tall (with pressure regulator fitted). T he pressure regulator outlet should be horizontal. 36 Instructions for the User 8. THE CONTROL PANEL All the appliance's control and monitoring devices are placed together on the front panel. The table below provides the key to the symbols used. RANGE BQ60S STANDARD BQ6030S BQ90S ELECTRONIC IGNITION BUTTON CENTRAL BURNER IGNITION KNOB LEFT BURNER IGNITION KNOB ULTRARAPID BURNER IGNITION KNOB RIGHT BURNER IGNITION KNOB 37 Instructions for the User BURNER CONTROL KNOB These knobs can be used to light the burners inside the barbecue. To light the flame, proceed as described in point "9. 3. 1 Electronic burner ignition". Burners can also be lit by hand; see point "9. 3. 2 Manual burner ignition (for internal burners only)" for further details. UR3 BURNER CONTROL KNOB (model BQ6030S only) This knob can be used to light the UR3 side burner (model BQ6030S only). Useful for conventional cooking or for keeping barbecued food hot. To light the flame, proceed as described in point "9. 3. 1 Electronic burner ignition". This appliance is not fitted with a safety valve. It therefore must never be left unattended when in operation. If you notice that the flames have gone out, turn the knobs to the OFF position AT ONCE and wait a few minutes before attempting to ignite the burners again. When the appliance is used for the first time, operate all the burners for 10 minutes with nothing on them to burn off any oils and manufacturing residues. WARNING: TO PREVENT COMBUSTION OF RESIDUE FROM PREVIOUS USE OF THE BARBECUE, CLEAN THE DRIPPING PAN, BURNER COMPARTMENT, CERAMIC PLATES AND THE BURNERS THEMSELVES BEFORE EACH USE. [. . . ] Wipe with a non-abrasive sponge, rinse thoroughly and dry with a soft cloth. For the best results, allow the degreasing detergent to act for some time. To eliminate yellowing, pour Crema inox onto a paper cloth and rub in the direction of the satin-finish. 12. 2 Cleaning the internal barbecue components 12. 2. 1 The ceramic plates The ceramic plates are made from refractory material and are therefore fragile; handle with care to avoid breakage. After each use, the burners should be operated with no food present at the maximum power for 10/15 minutes, to allow the plates to eliminate the food and grease residues accumulated during cooking. [. . . ]