User manual SMEG C60CEB

[. . . ] Clean inside the defrost water drain outlet on the rear wall of the refrigerator (near the fruit and vegetable crisper drawer) regularly, using the tool supplied with the appliance so as to ensure defrost water is removed correctly (see figure). Before all cleaning or maintenance procedures, unplug the appliance from the mains or disconnect the electricity supply. CHANGING THE BULB OR LED (depending on the model) Always unplug the refrigerator before replacing any light bulbs, then follow the relevant instructions in accordance with the type of lighting fitted in your appliance. Only use bulbs of the same type, which can be requested from the After-Sales Service and authorised dealers. Loosen the screws and take off the lamp cover. [. . . ] To defrost, unplug the appliance and remove all foodstuffs. Leave the door ajar to allow the frost to melt. For products with a freezer compartment below the refrigerator compartment, the defrost water drain pipe can be removed (see figure) and a recipient placed underneath. After defrosting, replace the drain pipe, making sure that no water is left in it. Clean inside the freezer compartment and dry carefully. Switch the appliance back on and place the food back inside. 12 MEAT & FISH BOX (depending on model) The Meat & Fish box was designed specially to keep foods fresher for longer, without altering nutritional values or original freshness. Do not store fruit or vegetables in this box, as the temperature may drop below 0°C, causing water contained in the food to freeze. Temperature Adjustment The temperature inside the Meat & Fish box is indicated by the position of the arm on the door of the box, and depends on the general temperature of the refrigerator compartment. We recommend setting the temperature of the refrigerator compartment between +2° and +6°. To work out if the temperature inside the Meat & Fish box is correct, refer to the pictures below: When the arm points to the left, you need to raise the temperature in the refrigerator compartment. When the arm is in the middle, the temperature is ok. When the arm points to the right, you need to lower the temperature in the refrigerator compartment. Important: when the function is activated and foods with a high water content are present, condensation may form on the shelves. In this case, disable the function temporarily. Removing the Meat & Fish box: The Meat & Fish box can be removed to create more space inside the refrigerator. To restore "Zero Degrees" box operation, make sure you replace the white plastic shelf underneath the box before inserting the drawer and reactivating the function. To optimise energy consumption, we recommend you deactivate the "Zero Degrees" box and remove it. Clean the box and all its parts regularly, using a cloth and a solution of warm water and neutral detergent specifically formulated for refrigerator interiors (take care not to immerse the white plastic shelf underneath the box in water). Before cleaning the box (including the outside), remove the drawer so as to disconnect the box from the electricity supply. Never use abrasive detergents. 14 AFTER-SALES SERVICE Before contacting the After-Sales Service: Switch the appliance on again to see if the problem has been solved. If it has not, unplug the appliance and wait for about an hour before switching on again. If the appliance is still not working after you have gone through all the checks listed in the troubleshooting guide and switched it off then on again, contact the After-Sales Service to explain the problem and have the following information ready: · the type of fault · the model · the type and serial number of the appliance (given on the rating plate) · the Service number (the number after the word SERVICE on the rating plate inside the appliance) Note: the door opening direction can be changed. If this operation is performed by the After-Sales Service it is not covered by the warranty. ELECTRICAL CONNECTION FOR GREAT BRITAIN AND IRELAND ONLY Warning - this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A. S. T. A. approved fuse to BS 1362 type and proceed as follows: 1. Fit replacement 13A fuse into fuse cover. Important: The fuse cover must be refitted when changing a fuse and if the fuse cover is lost the plug must not be used until a correct replacement is fitted. [. . . ] - The electric circuit safety devices installed in the house are fully functional. To switch off the acoustic alarm, press the mute alarm button and to remove an alarm completely, close the refrigerator door. On re-opening the door, check the light is working properly. Models with standard lights: unplug the appliance from the mains power supply, check the bulb and replace it if necessary with a new one (see section entitled "Changing bulb or LED"). [. . . ]