User manual SMEG CB320API

[. . . ] The user manual will help you use the product in a fast and safe way. • Read the manual before installing and operating the product. • Make sure you read the safety instructions. • Keep the manual in an easily accessible place as you may need it later. [. . . ] • The ambient temperature of the room where you install your refrigerator should at least be 10°C. Operating your refrigerator under cooler conditions is not recommended with regard to its efficiency. • Please make sure that the interior of your refrigerator is cleaned thoroughly. • If two refrigerators are to be installed side by side, there should be at least 2 cm distance between them. • When you operate your refrigerator for the first time, please observe the following instructions during the initial six hours. • The door should not be opened frequently. • It must be operated empty without any food in it. • Do not unplug your refrigerator. If a power failure occurs out of your control, please see the warnings in the “Recommended solutions for the problems” section. • Original packaging and foam materials should be kept for future transportations or moving. 12 EN 5 Using your refrigerator 1 2 3 4 5 6 7 Switching on for the first time To switch on the appliance be sure that the plug is inserted to the mains and the ON/OFF switch on the thermostat box is pushed. (Fig. 1-3) Insert the plug in mains socket to switch on. When you press fast freeze button (1), the orange indicator light (4) will go on and the compressor will run for about 24 hours. To cancel, press fast freeze button again and the orange light will go out. Fast freeze will cancel itself automatically after 24 hours, if you do not cancel it manually. The electronic control system incorporates a safety protection device so that if the fast freeze button (1) is pressed more than once, the compressor will not come on. Wait for about 10 minutes and try again. Self diagnostic: Your appliance incorporates a selfdiagnostic system. Certain characters (E0, E1, etc. ) will be displayed where the freezer temperature is usually shown. During this time red light (6) will flash. Please first see “trouble shooting” section and then “Service” section for further information. High freezer temperature warning light (RED) (6) If the freezer temperature becomes too high, then the warning indicator light (6) will flash. If the red indicator (6) remains on more than 12 hours, please contact with your service agency. [. . . ] • The items put onto the refrigerator may cause noise. >>>Remove the items on top of the refrigerator. There are noises coming from the refrigerator like liquid flowing, spraying, etc. • Liquid and gas flows occur in accordance with the operating principles of your refrigerator. [. . . ]