User manual SMEG CB320NFK

[. . . ] CB320 NFK en it pt fr es de Instruction Manual Manuale di istruzioni Notice d'Utilisation Manual de instrucciones Bedienungsanleitung Please read this user manual first!Dear Customer, We hope that your product, which has been produced in modern plants and checked under the most meticulous quality control procedures, will provide you an effective service. Therefore, read this entire user manual carefully before using the product and keep it as a reference. If you handover the product to someone else, give the user manual as well. [. . . ] • You may consult your authorized dealer or waste collection center of your municipality about the disposal of your refrigerator. Before disposing of your refrigerator, cut out the electric plug and, if there are any locks on the door, make them inoperable in order to protect children against any danger. Placing and Installation A If the entrance door of the room where the refrigerator will be installed is not wide enough for the refrigerator to pass through, then call the authorized service to have them remove the doors of your refrigerator and pass it sideways through the door. 1. Install your refrigerator to a place that allows ease of use. 2. Keep your refrigerator away from heat sources, humid places and direct sunlight. 9 EN Replacing the interior lamp Should the light fail to work, proceed as follows. 1. Switch off at the socket outlet and pull out the mains plug. You may find it useful to remove shelves for easy access. 2. Use a flat tipped screwdriver to remove the light diffuser cover. 3. First check that the lamp hasn’t worked loose by ensuring it is screwed securely in the holder. 4. If the lamp works, replace the light cover by inserting the rear lug and pushing up to locate the front two lugs. 5. If the light still fails to work, switch off at the socket outlet and pull out the mains plug. Replace the lamp with a new 15 watt (max) screw cap (SES) lamp. 6. Carefully dispose of the burnt-out lamp immediately. 7. Replacement light lamp can easily be obtained from a good local electrical or DIY store. 10 EN Reversing the doors Proceed in numerical order 11 EN 4 Preparation • Your refrigerator should be installed at least 30 cm away from heat sources such as hobs, ovens, central heater and stoves and at least 5 cm away from electrical ovens and should not be located under direct sunlight. • The ambient temperature of the room where you install your refrigerator should at least be 10°C. Operating your refrigerator under cooler conditions is not recommended with regard to its efficiency. • Please make sure that the interior of your refrigerator is cleaned thoroughly. • If two refrigerators are to be installed side by side, there should be at least 2 cm distance between them. • When you operate your refrigerator for the first time, please observe the following instructions during the initial six hours. • The door should not be opened frequently. • It must be operated empty without any food in it. • Do not unplug your refrigerator. If a power failure occurs out of your control, please see the warnings in the “Recommended solutions for the problems” section. • Original packaging and foam materials should be kept for future transportations or moving. 12 EN 5 Using your refrigerator Defrost Fridge compartment Fridge compartment performs fullautomatic defrosting. [. . . ] • Fans are used in order to cool the refrigerator. Condensation on the inner walls of refrigerator. • Hot and humid weather increases icing and condensation. • Doors are opened frequently or left ajar for a long time. [. . . ]