User manual SMEG CB61VE

[. . . ] 6 Switching on . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Selecting and starting the program. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 End of program . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Interrupting a program. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Before loading the dishes into the racks it is necessary to: · remove coarse food remains: e. g. which may clog the filter or damage the wash pump; · soak any pots or pans with burnt-on food remains on the bottom to facilitate removal, then load them into the LOWER RACK. Use the "½ load wash" option (if available) for washing small amounts of dishes; it saves water and electricity. When using this function, only load the rack selected for the ½ load wash; the other rack must remain empty. There is no need to pre-wash the dishes under running water before loading them into the racks since this only wastes water. Correct loading of the dishes helps ensure optimal washing results. WARNING! · make sure that the dishes are securely in place so that they cannot tip over or obstruct the rotation of the spray arms during the washing cycle; · do not place very small objects in the racks as these could fall and obstruct the spray arms or the wash pump; · containers such as cups, bowls, glasses and pots should always be loaded with the opening facing downwards and with any cavities at an angle, to allow the water to drain out; · do not stack dishes or place them in such a way that they cover one other; · do not place glasses too close together because they may knock against each other and break, or there might be staining at the point where they touch. 22 Rev 0. 0 USER INSTRUCTIONS MAKE SURE that the items being washed are dishwasher-safe. Items which are not dishwasher-safe: · Wooden dishes, pots or pans: these may be damaged by the high washing temperatures. · Handcrafted items: these are rarely suitable for washing in a dishwasher. The relatively high water temperatures and the detergents used may damage them. · Lightweight objects: place lightweight objects in the upper rack where the water pressure is lower. The dishwasher is complete with two cutlery baskets, which means that one of them can be removed, freeing space in the bottom rack, if there is not much cutlery to be washed, or if a ½ load program is being used (on models with this function). The baskets feature an exclusive system of independent sliding tip-up supports, offering a choice of combinations to allow optimum use of the space available. Inserto Horizontal orizzontale insert closed chiuso Inserto Horizontal orizzontale insert open aperto Vertical inserts Inserti verticali Movement required Movimento per to extract the inserts l'estrazione degli inserti Fig. 4-11 Rev 0. 0 27 EN USER INSTRUCTIONS pla_68xu: The cutlery supports and central lid are in the bag of accessories. 4-12) is intended to act only as a cover; do not place the cutlery in it. A Fig. 4-12 28 Rev 0. 0 USER INSTRUCTIONS 4. 4. 3 Upper rack (see fig. 4-13) EN It is recommended to load the upper rack with small- or medium-sized items such as glasses, small plates, tea or coffee cups, shallow bowls and light objects made from heat resistant plastic. If the upper rack is used in the lowermost position, it can also be loaded with serving dishes, provided they are only slightly soiled. The top rack is fitted, on the left, with two plastic racks which can be raised to make room for tall glasses, such as stem glasses. Fig. 4-13 Rev 0. 0 29 EN USER INSTRUCTIONS Loading the upper rack (see fig. 4-14) Load plates facing forward; cups, bowls etc. The left-hand side of the rack can be loaded with two layers of cups and glasses. [. . . ] 5-27 Use the screwdriver to secure the door hooks with the 8 supplied screws (see fig. 5-28) at the marked reference points. Fig. 5-28 Rev 0. 0 31 EN INSTALLATION INSTRUCTIONS If a gap is created between the control panel and the door panel (ref. The number of strips depends on the size of the gap. B A Fig. [. . . ]