User manual SMEG CB81VGT

[. . . ] Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. Do not flamb under the range hood; risk of fire This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. 650 mm min. MAINTENANCE Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. Clean and/or replace the Filters after the specified time period (Fire hazard). [. . . ] Place the drilling template 21 provided on the ceiling/support shelf, making sure that the template is in the correct position by lining up the axes of the template with those of the hob. Mark the centres of the holes in the template. Drill the holes at the points marked: For concrete ceilings, drill for plugs appropriate to the screw size. For hollow brick ceilings with wall thickness of 20 mm: drill 10 mm(immediately insert the Dowels 11 supplied). For wooden beam ceilings, drill according to the wood screws used. For the power supply cable feed, drill 10 mm. For the air outlet (Ducted Version), drill according to the diameter of the external air exhaust duct connection. Insert two screws of the following type, crossing them and leaving 4-5 mm from the ceiling: For concrete ceilings, use the appropriate plugs for the screw size (not provided). for Cavity ceiling with inner space, with wall thickness of approx. For wooden beam ceilings, use 4 wood screws (not provided). For wooden shelf, use 4 screws 12g with washers 22 and nuts 23, provided. EN 1 17 7 Fixing the frame Loosen the two screws fastening the lower chimney and remove this from the lower frame. If the filter saturation alarm is on, this resets it. Press once to turn the suction motor on and off at speed three. Press again to activate intensive speed. This speed is timed to run for 10 minutes. At the end of this time the system will Flashing. automatically return to the speed set before. Suitable to deal with maximum levels of cooking fumes, it is deactivated by pressing any one of the Speed buttons (T1-T2-T3). It cannot be activated if the Delay function is in use. If the filter saturation alarm is on, this resets it. Activate automatic switch-off with a 30' delay (Motor+Lights). Suitable to complete elimination of residual odours. [. . . ] Wash the Filters without bending them, and leave them to dry completely before replacing. Replace, taking care to ensure that the handle faces forwards. EN 2 22 2 Activated Charcoal Filter (Recirculation Version) This cannot be washed or regenerated, and must be changed when all the command LEDs start to flash, or at least once every 4 months. Activating the alarm signal In Recirculation Version Hoods, the Filter Saturation Alarm must be activated on installation or at a later date. Press and hold the Delay button (T4) on the keypad for 5 seconds and the following will be displayed: Leds (L1-L2-L3) flash twice Activated Charcoal Filter saturation alarm ACTIVATED. [. . . ]