User manual SMEG CB90EV-1

[. . . ] Do not plug the power supply with wet hands. Never touch the machine with wet hands or feet. Never open the detergent drawer while the device is running. Never force to open the door of the machine while the machine is running. [. . . ] · Turn the program knob to "Draining" or "Spinning" programs. · The program ready light will be on. · Run the program you have selected by pressing the start/pause button. Program ending · Your machine will automatically stop when the program you have selected ends. · The program end light will be on. · Turn the program knob to O(off) position. 39 · · · · The door will be unlocked in approximately two minutes after the program ends. You can open the door by pulling the handle of the door towards yourself and take out your clothes. After you unload your clothes leave the door open to dry the interior of your machine. Close the water tap. WARNING! If the power is off end on again after a while on any stage of the washing program, your machine will continue the program from the point where it was interrupted. This is not harmful for your machine. Child lock The Child Lock prevents unauthorised changes on the control panel while the machine is in operation. The child lock will be activated after the start/pause button on the control panel is pressed for a period longer than 2 seconds. Fit the cleaned siphon plug in its location. Check if it placed properly. THE CABINET Clean the exterior surface of the cabinet of your machine with lukewarm water and a cleaning substance that will not irritate the cabinet. After rinsing with clean water, wipe it with a soft and dry cloth. WARNING! If the machine is installed in a location where the ambient temperature can fall below 0 °C, do the following when it will not be in use: · Plug in the machine. · Close the water tap and pull out the water inlet hose or hoses from the tap. · Place the ends of the water drain and water inlet hoses in a cup on the ground. · Adjust the program knob to "Draining" program. · The program ready light will be on. · Run the program by pressing the start/pause button. · Unplug your machine when the program is over (program end light is on). When you complete these proces, the remaining water inside the machine will be drained and thus formation of ice in the machine will be prevented. When you operate your machine again, be sure that the ambient temperature is above 0 °C. [. . . ] Use only the detergents produced for full automatic machines. (see Table-1) Use more detergent according to the detergent. Wrong detergent has been used. The washing result is bad. Your laundry too dirty for the program you have selected. The amount of detergent used is not sufficient. 49 FAILURE PROBABLE CAUSE Clothes exceeding the maximum capacity has been filled in your machine. The washing result is not good. Your water may be hard. Distribution of the clothes in your machine is not wellbalanced. [. . . ]