User manual SMEG CB91VG

[. . . ] · Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. · Do not flambè under the range hood; risk of fire · This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. · Children should be supervised to ensure that they do not play with the appliance. 650 mm min. MAINTENANCE · Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. · Clean and/or replace the Filters after the specified time period (Fire hazard). [. . . ] · Place the drilling template 21 provided on the ceiling/support shelf, making sure that the template is in the correct position by lining up the axes of the template with those of the hob. · Mark the centres of the holes in the template. · Drill the holes at the points marked: · For concrete ceilings, drill for plugs appropriate to the screw size. · For hollow brick ceilings with wall thickness of 20 mm: drill ø 10 mm(immediately insert the Dowels 11 supplied). · For wooden beam ceilings, drill according to the wood screws used. · For wooden shelf, drill ø 7 mm. · For the power supply cable feed, drill ø 10 mm. · For the air outlet (Ducted Version), drill according to the diameter of the external air exhaust duct connection. · Insert two screws of the following type, crossing them and leaving 4-5 mm from the ceiling: · For concrete ceilings, use the appropriate plugs for the screw size (not provided). · for Cavity ceiling with inner space, with wall thickness of approx. · For wooden beam ceilings, use 4 wood screws (not provided). Replace then the elements as earlier described. · Fit the directional grids 8a - 8b in their housings making sure that the directional symbols are towards the top. Also make sure that they are correctly inserted in the connection extension pieces 14. 1. Before fixing the hood canopy to the frame: · Screw the 2 screws 12f half way into the holes provided in the sides of the bottom of the frame. · Remove the grease filters from the hood canopy. · Remove any activated charcoal filters. · Lift the hood canopy and engage the screws 12f in the slots (A) as far as they will go. Activate automatic switch-off with a 30' delay (Motor+Lights). Suitable to complete elimination of residual odours. Can be activated from any Speed, and is disabled by pressing the button again or turning the motor off. It cannot be activated if the Intensive function is in use. [. . . ] · Replace, taking care to ensure that the handle faces forwards EN 2 22 2 Activated Charcoal Filter (Recirculation Version) · This cannot be washed or regenerated, and must be changed when all the command LEDs start to flash, or at least once every 4 months. Activating the alarm signal · In Recirculation Version Hoods, the Filter Saturation Alarm must be activated on installation or at a later date. · Press and hold the Delay button (T4) on the keypad for 5 seconds and the following will be displayed: · Leds (L1-L2-L3) flash twice ­ Activated Charcoal Filter saturation alarm ACTIVATED. · Leds (L1-L2-L3) flash once ­ Activated Charcoal Filter saturation alarm DEACTIVATED. [. . . ]