User manual SMEG CF31BPNF

[. . . ] RATING 230 - 240 V~ 50/60 Hz 7000 W USE 1) SWITCHING ON THE ELECTRIC PLATES The hobs may be equipped with three types of electric plates: normal, thermostat and rapid plates indicated by a red mark. The normal plates and the rapid plates are controlled by a 7 - position switch (see fig. The thermostat plates are controlled by 12 - position switch (see fig. Switch on the plates by turning the knob to the required position. [. . . ] - To dry the bottom of the pan before placing it on the plate. - Correctly preserve the plate after use by treating it with special products, easily available on the market. This will keep the surface of the plate clean and bright. The operation will also prevent the formation of rust. Never allow children to play near the appliance when using the plates. Check that the pan handles are positioned correctly. The user should never leave the appliance unattended when cooking with easily inflammable oil and fat. - The plates will remain hot for a long period of time even after use. Never touch them with the hands or other objects in order to prevent scorching. - If the appliance has a glass lid, this could shatter when the cooker becomes hot. Always disconnect all the plates before closing the lid. 10 8 5 INSTALLATION Installation and maintenance must only be carried out by a qualified installer. Incorrect installation could cause damage to persons, animals and property for which the manufacturer cannot be held responsible. - Overturn the hob and correctly position seal "E" (fig. 6) under the edge of the hob itself, so that the outer part of the seal itself perfectly matches the outer perimetral edge of the hob. The ends of the strips must fit together without overlapping. - Evenly and securely fix the seal to the hob, pressing it in place with the fingers. - Remove the strip of protective paper from the seal "F" it the hooks into their relative housings "K" in the unit and set the hob into the hole in the cabinet. Lock it in place with the relative fixing screws "F" (see fig. WARNINGS: Be aware that the glue that join the laminated plastic to the furniture, has to resist to temperature not below 150° C, to avoid the unstuck of the panelling. The installer should bear in mind that the mixed appliance is the Y type. The rear wall, adjacent and surrounding surfaces must therefore be able to withstand an overtemperature of 65 K. INSTALLATION 6) ELECTRICAL CONNECTIONS Electrical connection must be carried out in compliance with the specifications and provisions in force. [. . . ] - Alternatively, the electrical connection may also be protected by a high sensitivity differential switch. Installers are strongly advised to connect the yellow- green earthing wire to an efficient earthing system. The manufacturer cannot be responsible for the missing earthing of the appliance. WARNINGS: All our appliances are designed and manufactured in compliance with European standards EN 60 335-1 and EN 60 335-2-6 plus the relative amendments. [. . . ]