User manual SMEG CO200

[. . . ] Red LED (if provided): indicates that the appliance temperature is not sufficiently low. 3. Green LED (if provided): indicates that the appliance is on. 1. Defrost water drain plug (depending on model). Condenser (located at the rear). Climatic Class SN N ST T Amb. [. . . ] Install the appliance in a dry and well-ventilated place. The appliance is set for operation at specific ambient temperature ranges, according to the climatic class indicated on the data plate located at the rear of the product. The appliance may not work properly if it is left for a long period at a temperature above or below the indicated range. If the appliance is left empty for short periods, it is preferable not to switch it off. Be careful not to damage the floors when you move the appliance (e. g. Do not use mechanical devices or any means other than those recommended by the manufacturer to speed up the defrosting process. Do not use electrical appliances inside the product, unless such appliances are specifically recommended by the manufacturer. This appliance is not designed for use by young children or the infirm without supervision. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. The power cable may only be replaced by an authorized person. Electrical disconnection must be possible either by unplugging the appliance or by means of a double-pole switch located upline from the socket. Ensure that the voltage indicated on the appliance data plate corresponds to the domestic supply voltage. Do not ingest the contents (non-toxic) of the ice packs (if provided). Restrict the number of times you open the lid. · · · · · drainage channel to collect the residual water. Speed up defrosting by using a spatula to detach the ice from the appliance walls. Remove the ice from the bottom of the appliance. In order to avoid permanent damage to the appliance interior, do not use pointed or sharp metal instruments for removing the ice. Do not use abrasive products or heat up the interior artificially. Dry the interior of the appliance thoroughly. On completion of the defrosting, refit the plug. CARE AND MAINTENANCE · Remove the ice from the upper edge (see the Troubleshooting Guide). · Clean the inside after defrosting, using a sponge dampened with warm water and/or mild detergent. · Clean the side motor cooling grille (depending on model). · Remove dust from the condenser on the rear of the appliance. Before carrying out maintenance, unplug the appliance. [. . . ] Contact the After Sales Service for a replacement. · Have hot foods been put in the appliance?· Has the appliance lid been left open for a long time?· Is the appliance placed in a very warm room or near heat sources? [. . . ]