User manual SMEG CS18NLA2

[. . . ] ALSO KEEP THE SERIES OF NOZZLES SUPPLIED. INSTALLATION MUST BE CARRIED OUT BY QUALIFIED PERSONNEL IN ACCORDANCE WITH THE REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTIC USES AND CONFORMS TO CURRENT REGULATIONS IN FORCE. THE APPLIANCE HAS BEEN BUILT TO CARRY OUT THE FOLLOWING FUNCTIONS: COOKING AND HEATING-UP OF FOOD. [. . . ] Pull out knob A and, turning it clockwise, align pointer C with the hours pointer. Now turn the knob A clockwise again until the symbol appears in window B. 46 Instructions for the user 5. 3 Electronic Analogue Clock (on some models only) LIST OF FUNCTIONS TIMER KEY END OF COOKING KEY TIME SETTING AND RESET VALUE DECREASE KEY VALUE INCREASE KEY 5. 3. 1 The buzzer that sounds at the end of each programming will be made up of 10 buzzes repeated 3 times at intervals of about 1 minute. This sequence can be stopped at any time by pressing any key. 5. 3. 2 Setting the time When using the oven for the first time, or after a power failure, the display flashes at regular intervals. Press the key to stop the display flashing. Press key again for 2 seconds; the current time can now be set. Press the value modification buttons or to increase or decrease the setting by one minute for each pressure. Press either of the value modification keys to display the current time. Five seconds after last pressing the key, the clock will start from the set time. 47 Instructions for the user 5. 3. 3 Timer This function only activates the buzzer, without stopping cooking. Press and the display will light up as shown in figure 1; Within 5 seconds press key or to set the timer. To set the cooking start/end time, proceed as follows: Set the cooking duration as described in the previous point. If the burners should go out accidentally, after about 20 seconds a safety device will be tripped, cutting off the gas supply, even if the gas tap is open. 51 Instructions for the user 6. 2 Practical advice for using the cooking hob burners For better burner efficiency and to minimise gas consumption, use pans with lids of suitable size for the burner, so that flames do not reach up the sides of the pan (see point "6. 3 Pan Diameters"). Once the contents come to the boil, turn down the flame far enough to prevent the liquid from boiling over. When cooking, to prevent burns or damage to the hob all pans or griddle plates must be placed inside the perimeter of the hob. All pans must have smooth, flat bottoms. Take the greatest care when using fats or oils since they may catch fire if overheated. If the flame accidentally goes out, turn off the control knob and wait at least 1 minute before trying to re-light the burner. 6. 3 Pan diameters BURNERS Ø min. (in cm) 12-14 16-20 18-26 20-26 use special oval-shaped pan 1 2 3 4 5 Auxiliary Semi rapid Rapid Ultra rapid Fish burner 52 Instructions for the user 7. USING THE OVEN Before using the oven make sure that the analogue programmer shows the symbol (see paragraph "5. 2. 4 Manual mode cooking "). In models equipped with analogue digital timer, the user has only to press the central key for 1/2 seconds to enable use of the oven on first use or after a power blackout. 7. 1 General warnings and advice When the oven is used for the first time, it should be heated to the maximum temperature for long enough to burn off any oily residues left by the manufacturing process, which might contaminate foods with unpleasant odours. To prevent any steam in the oven from causing problems, open the door in two stages: hold it half-open (about 5 cm) for 4-5 seconds, then open it completely. To access food, always leave the door open for as short a time as possible to prevent the temperature in the oven from falling and ruining the food. During cooking, do not cover the bottom of the oven with aluminium or tin foil, and do not place pans or trays on it; this may damage the enamel coating. [. . . ] Remove the pan stands and wash them in warm water with a non-abrasive detergent, taking care to remove all encrustations, and wait until they are completely dry. Replace the flame-spreader crowns, checking that they are correctly in place with their respective burner caps, making sure that the holes A in the flame-spreader crowns are aligned with the plugs and thermocouples. 10. 2. 3 Ignition plugs and thermocouples For best performance, the ignition plugs and thermocouples must always be kept thoroughly clean. Check them frequently and if necessary clean them with a wet cloth. Remove any dry residues with a wooden toothpick or a needle. 10. 3 Cleaning the oven To keep the oven in good condition, it must be cleaned regularly, after allowing it to cool down. [. . . ]