User manual SMEG CT29X

[. . . ] TROUBLESHOOTING. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 EN Rev 0. 0 1 EN 2 Rev 0. 0 INTRODUCTION 1 INTRODUCTION Thank you for choosing one of our products. To use this dishwasher correctly and safely, please read this manual carefully. The manual is divided into sections giving you a step-by-step guide to all your appliance’s functions. [. . . ] The tables are numbered in the same way, bearing in mind that “Tab. ” is used instead of “Fig. ” (e. g. : Tab. If a table occupies more than one page, a letter is added after the progressive number (e. g. : “Tab. 4-01b”). EN Rev 0. 0 3 EN INTRODUCTION Symbols used in this manual (see tab. This symbol highlights information and warnings which, if not observed, may compromise personal safety or damage the appliance. This symbol highlights general information and warnings. 1-01 4 Rev 0. 0 USER INSTRUCTIONS 2 2. 1 DESCRIPTION AND USE OF THE CONTROLS Upper panel EN All the dishwasher controls are grouped on the upper panel (see fig. The dishwasher can only be switched on, programmed, switched off, etc. 2-01) of the various controls on the upper panel is given below. 2 end 3 4 1 Fig. 2-01 On/off button Press to power the appliance. Program indicator lights These show which program is selected and whether there are any faults (troubleshooting). Program selection button Press in sequence to select the required program. Add rinse-aid indicator light Shows the appliance has run out of rinse-aid. 1 2 3 4 Tab. Wait for about 1 minute before closing the door and continuing with the program. When the door closes, the program will start from where it was interrupted. This operation should be performed only if necessary as it could cause irregular program performance. EN 2. 2. 5 Changing the current program To change the current program, simply open the door of the dishwasher and select the new program. Close the door to run the new program automatically. 2. 2. 6 Canceling the current program • To cancel the current program, open the door and press and hold down the program selection button (ref. 2-02) for a few seconds until the indicator lights of the fourth and fifth programs turn on (ref. • After about 1 minute, the dishwasher terminates the cycle and the indicator lights of the fourth and fifth programs (ref. 2-03 Rev 0. 0 9 EN 2. 2. 7 Switching off USER INSTRUCTIONS At the end of the program, the dishwasher emits a short beep and the indicator lights of the fourth and fifth program (ref. Turn off the appliance by opening the door and pressing the on/off button (ref. 2-04 10 Rev 0. 0 USER INSTRUCTIONS 3 • • • • • EN ENERGY SAVING AND ENVIRONMENTAL RESPECT Always try to run the dishwasher fully loaded. Do not wash the dishes under a running tap. Use the most suitable washing program for each type of load. [. . . ] If the problem persists, contact the technical assistance service. Water intake malfunction The appliance does not take in water or does so incorrectly. Make sure the water connections are correct, that the water supply tap is open and that the filter is not clogged. If the problem persists, contact the technical assistance service. [. . . ]