User manual SMEG CWG430SDE

[. . . ] CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor to moderate injury. All safety messages will inform you of potential hazards, on how to reduce the risk of injury and what can occur if the instructions are not followed. IMPORTANT: Installation and grounding must comply with applicable codes. Observe all governing codes and ordinances. - This appliance is intended for use in the home only. [. . . ] Improper use of the appliance can result in personal injury and material damage. Read all the instructions before installing or using the oven for the first time. Keep these operating instructions in a safe place and pass them on to any future user. WARNING - - SAVE THESE INSTRUCTIONS 4 Important Safety Instruction 2. GENERAL INSTALLATION INSTRUCTIONS · Proper installation is your responsibility. Have a qualified technician install this oven. Make sure you have everything necessary for proper installation. It is the responsibility of the installer to comply with installation information specified on the model/serial ID plate. The model/serial ID plate can be found on the internal frame of the oven when the door is opened. Have your oven installed and properly grounded by a qualified installer, in accordance with these installation instructions. Grounding is mandatory according to the provisions of electrical safety codes. If this appliance is connected to an external electrical power supply, it must be grounded in compliance with local codes, or, if no local codes exist, in compliance with the national ANSI / NFPA 70 code of electrical regulations. · Slide the oven on the cardboard close to the oven's final location. · Remove the oven door (see paragraph "9. 2 Removing the door" in the Instructions for the User booklet) IMPORTANT: Use both hands to remove the oven door. 6 Instructions for the Installer 4. MAKING THE ELECTRICAL CONNECTION ELECTRICAL SHOCK HAZARD WARNING - Disconnect the power to the junction box before making the electrical connection, Electrically ground the appliance with green or green-yellow wire - FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN DEATH, FIRE OR ELECTRICAL SHOCK. This appliance is manufactured with a yellow-green or green ground wire connected to the oven frame. To prepare the connection between the oven and the junction box: Disconnect the power supply to the junction box. Feed the flexible cable conduit from the oven through the opening of the cabinet. Remove the junction box cover, if present. Install a UL-listed or CSA-approved conduit connector to the junction box. Route the flexible cable conduit from the oven to the junction box through a UL-listed or CSAapproved conduit connector. Tighten the screws on the conduit connector. Refer to pictures 1 and 2 below, which represent the most common way of making the electrical connection. IMPORTANT: Any local codes and ordinances should be given priority over these instructions. [. . . ] If a new installation conforming to 1996 NEC or if local codes do not permit grounding through the neutral wire, separate the neutral and ground wires that extend out of the oven cable and connect the ground wire to the grounding system in the standard manner. Connect the neutral wire or lead to the power supply's neutral cable: - Separate the ground and neutral wires at the free end of the oven cable. - Connect the grounding lead or wire to grounding system, and - Connect the neutral lead or wire to the neutral from the power supply in the standard manner (see pic. 2 below) 7 Instructions for the Installer U. S. [. . . ]