User manual SMEG DHT71EIT

[. . . ] Pay attention to all details and warnings specified in the user manual and follow the instructions given therein. Use this user manual for the model indicated on the cover page. Explanation of symbols Throughout this user manual the following symbols are used: C A B Important information or useful hints about usage. Warning for hazardous situations with regard to life and property. Warning against electric shock. Warning against hot surfaces. Warning against fire hazard. [. . . ] Fasten the zippers, hooks and buckles and button sheets. Following information will help you use the dryer in an ecological and energy-efficient manner. • Spin your laundry at the highest speed possible when washing them. Thus, the drying time is shortened and energy consumption is reduced. (See 5. 7 Programme selection and consumption table) • Sort out the laundry depending on their type and thickness. For example thin kitchen towels and table clothes dries earlier than thick bathroom towels. (See 5. 7 Programme selection and consumption table) • Follow the instructions in the user manual for programme selection. • Do not open the loading door of the machine during drying unless necessary. If you must certainly open the loading door, do not to keep it open for a long time. • Do not add wet laundry while the dryer is in operation 14 / 56 EN Dryer / User Manual Iron without steam Iron at medium temperature Iron at low temperature Dry-cleanable At medium temperature Hang to dry Drying Settings At low temperature Lay to dry Preparation • • Clean the lint filter before or after each drying cycle. Maintenance and cleaning) Clean the filter drawer regularly either when the Filter Drawer Cleaning warning symbol appears or after every 5 drying cycles. Maintenance and cleaning) Ventilate the room, where the dryer is located, well during drying. C Laundry It is not recommended to load the dryer with laundry exceeding the level indicated in the figure. Drying performance will degrade when the machine is overloaded. Furthermore, dryer and the laundry can get damaged. • Following weights are given as examples. 1. Open the loading door and place your laundry. Press the end duration selection button and set the delay duration you want. (End duration moves continuously when you keep pressing the button). The “:” sign in the middle of the displayed delay duration blinks. Fiber filter cleaning When the program is completed, a warning led lights up, which indicates that the filter has to be cleaned. C You can add or remove laundry for the duration of the end duration. The duration displayed on the screen is the sum of the normal drying duration and the end duration. At the end of the countdown the end duration led turns off, drying beings and drying led lights up. Changing the end duration C If the filter cleaning led blinks, see the „Troubleshooting“ chapter. Water tank When the program is completed, a warning led lights up, which indicates that the water tank must be emptied. If the water tank fills up while the program is running, warning led starts blinking and the machine goes into stand-by. In that case empty the water in the water tank and start the program by pressing the Start / Pause button. Warning led turns off and the program resumes. If you want to change the duration during the countdown: 1. Cancel the program by pressing the On/Off button. Turn on the drying machine again by pressing the On/Off button. When your drying machine turns on for the first time, it turns on with the declaration (cotton wardrobe dryness) program. [. . . ] Programme is not selected or the Start / Pause / Cancel button is not pressed. >>> Make sure that the programme is selected and the machine is not in Pause mode. >>> Deactivate the Childproof Lock. C After drying, the hot clothes feel damper than their actual dampness level. Programme is interrupted without any cause. >>> Make sure that the loading door is closed securely. [. . . ]