User manual SMEG DOSFA38X

[. . . ] Contents 1. 1 1. 2 1. 3 1. 4 1. 5 1. 6 1. 7 2. 1 2. 2 2. 3 2. 4 How to read the user manual This user manual Appliance purpose General safety instructions Manufacturer liability Identification plate Disposal General Description Control panel Other parts Available accessories Instructions First use Using the accessories Using the oven Cooking advice Programming clock 4 4 4 4 5 5 5 2 Description 6 6 7 7 8 3 Use 3. 1 3. 2 3. 3 3. 4 3. 5 3. 6 10 10 10 11 12 13 15 4 Cleaning and maintenance 4. 1 Instructions 4. 2 Cleaning the surfaces 4. 3 Ordinary daily cleaning 4. 4 Food stains or residues 4. 5 Removing the door 4. 6 Cleaning the door glazing 4. 7 Removing the internal glass panels 4. 8 Cleaning the inside of the oven 4. 9 Vapor Clean: assisted oven cleaning (on some models only) 4. 10 Extraordinary maintenance 20 20 20 20 20 20 21 21 22 24 25 5 Installation 5. 1 Electrical connection 5. 2 Cable replacement 5. 3 Positioning 27 27 28 28 We advise you to read this manual carefully, which contains all the instructions for maintaining the appliance's aesthetic and functional qualities. For further information on the product: www. smeg. com 3 EN 1 Instructions 4 Instructions 1 Instructions 1. 1 How to read the user manual This user manual uses the following reading conventions: Instructions General information on this user manual, on safety and final disposal. Description Description of the appliance and its accessories. Use Information on the use of the appliance and its accessories, cooking advice. [. . . ] To set the cooking time press key or within 5 seconds: each pressure on adds 1 minute to the cooking time, and every 12 minutes a new internal segment will light up (the example below shows a cooking time of 1 hour). 3. Once the required time is obtained, cooking will start about 5 seconds after the last pressure on or . The display will show the current time, represented by the constantly illuminated segments, and the minutes left to the end of cooking, represented by the flashing 15 EN 3. 6 Programming clock Timed cooking Use segments (each flashing segment means 12 minutes of cooking time left). At the end of cooking, the timer will switch the oven heating elements off, the buzzer will start to sound and the numbers on the dial will flash. The set program can be cancelled: press key for 2 seconds to cancel the set time and switch the oven off manually if a cooking operation is in progress. It is not possible to set a cooking time of more than 12 hours. Programmed cooking Programmed cooking is the function which allows a cooking operation to be started at a set time and then ended after a specific length of time set by the user. Set the cooking time as described in the previous point “Timed cooking”. Within 5 seconds of last pressing key or , press key again to set the cooking end time. Symbol will flash on the display together with the current time, with the internal segments illuminated to show the end of cooking time. Press key or to set the cooking end time. 5 seconds after the last key is pressed, the display will show the current time and the cooking start and end times, represented by the illuminated internal 16 segments. As soon as the current time reaches the set cooking start time, the internal segments will flash and the oven starts cooking. At the end of cooking, the timer switches the oven heating elements off, the buzzer starts to sound and the numbers on the dial flash. The set program can be cancelled: press key for 2 seconds to cancel the set time and switch the oven off manually if a cooking operation is in progress. • In the example below, the current time is 7. 06 and cooking is programmed to start at 8. 00 and end at 9. 00. • At 8 o'clock the internal segments between 8 and 9 will start to flash. For the oven to start cooking after the programming procedures just described, the knobs must be correctly set on the required temperature and function. Display reduced brightness To reduce energy consumption in stand-by, briefly press key to reduce the display brightness. To restore the normal brightness, press again. Use EN 17 Timer This function only activates the buzzer, without stopping cooking. Press and the display will light up as shown in the figure below. 5. Press again to return to the timer display. At the end of the countdown turn the temperature and function knobs to O to manually stop the cooking operation. [. . . ] Pull the 4 edges of the seal outwards to detach the fasteners. Do not touch the halogen lamp directly with your fingers, but wrap it in an insulating material. 26 Installation EN 27 5 Installation 5. 1 Electrical connection Power voltage Danger of electrocution • 380-415 V 2N~ Use a 4 x 2. 5 mm² four-core cable. • Have the electrical connection performed by authorised technical personnel. • The appliance must be connected to earth in compliance with electrical system safety standards. • Disconnect the main power supply. [. . . ]