User manual SMEG ELPI5SJ10

[. . . ] We have provided many important safety messages throughout this manual and on your appliance. Read all instructions before using your appliance and always obey all safety messages. RECOGNIZE SAFETY INFORMATION This is a safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. UNDERSTAND SIGNAL WORDS A signal word ­ DANGER, WARNING, or CAUTION ­ is used with the safety-alert symbol. [. . . ] Never modify or alter the construction of the appliance. For example, do not remove leveling legs, panels, wire or anti-tip brackets/screws. - CAUTION: This unit is design as a cooking appliance. Based on safety considerations, never use it for warming or heating a room. Do not obstruct ventilation openings and heat dispersal slits. Immediately after installation carry out an inspection test of the appliance, following the instructions on this booklet. If the appliance doesn't work properly, disconnect it from the electrical and gas supply and call the technical assistance centre. Any adjustment and servicing must be performed only by qualified cooker installers or service technicians. Do not leave the packaging in the home environment. Separate the various waste materials and take them to the nearest special wastage collection centre. - - SAVE AND KEEP THIS BOOKLET 5 Instructions for the Installer 2. DIMENSIONAL REQUIREMENTS 1 24" (61 cm) min. when bottom of wood or metal cabinet is protected by not less than ¼ " (0. 64 cm) flame retard millboard covered with not less than No. The weight must be supported uniformly across the bottom. After transporting the professional range close to its final location, the range can be tipped back and supported on the rear legs while the dolly is carefully removed. The floor under the legs should be protected (wood, strips, carpet, paneling, and similar) before pushing the unit into position. The anti-tip device must be installed, gas and electrical connections should be made before the range is placed in its final position. For porper performance the professional range must be leveled. The range is leveled by adjusting the four feet to set the appliance on a perfect level plane. For this purpose, loosen the lock nut and unscrew the foot. The range of adjustment of the screw is 10mm. Ensure that the burner caps are correctly seated on the burner bases of the range's cooktop. - - - 8 Instructions for the Installer 4. WALL FIXING AND ANTI-TIP DEVICE WARNING All ranges can tip Injury to persons could result Install anti-tip device packed with the range See installation instructions FAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT IN DEATH OR SERIOUS BURNS TO CHILDREN OR ADULTS. ELECTRIC SHOCK HAZARD WARNING - Use extreme caution when drilling holes into the wall or floor. There may be concealed electrical wires located behind the wall or under the floor. [. . . ] After making sure that the power has been turned off connect the flexible connector. Picture 1 and 2 on page 12 connecting the appliance to the junction box using a UL listed conduit connector. Picture 1 and Picture 2 on page 12, and the instruction provided below present the most common way of connecting the appliance. Your local codes and ordinaces, of course, take precedence to these instructions. [. . . ]