User manual SMEG F-1036IT

[. . . ] 8 3. 2 Your environmental care . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GET TO KNOW YOUR APPLIANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 4. 1 Description of the controls on the front panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AVAILABLE ACCESSORIES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Then prepare the rotisserie rod with the food, using the clip forks provided. So that you can handle the rod with the food on it readily, screw on the handle provided. Having prepared the rotisserie rod with the food, position it on the guide frame as shown in the figure. Insert the rod into the hole (detail B) so that it connects with the rotisserie motor. Make sure that the pin is placed correctly on the guide frame (detail A). 12 Instructions for the user 6. USING THE COOKING HOB 6. 1 General warnings and advice The appliance has 4 cooking zones of various diameters and power levels. Their position is clearly indicated with circles and heat is released within the diameters traced on the glass ceramic surface. The 4 cooking zones are HIGH-LIGHT zones and come on a few seconds after activation. The heat intensity can be adjusted using the knobs located on the front panel from a minimum to a maximum value. The cooking zones indicated by two concentric circles circle + fish burner circle or in both circles. and by a allow double heating, either within the inner The four indicator lights located between the cooking zones come on when the temperature of one or more of the radiating zones exceeds 60°C. These lights switch off when the temperature falls below approximately 60°C. When the hob is used for the first time, you are advised to heat it to the maximum temperature long enough to burn off any oily residues from manufacturing in order to ensure that the food does not absorb odours. While cooking desserts or vegetables, excessive condensation may form on the glass. In order to avoid this, open the door very carefully a couple of times while cooking. To prevent hazardous overheating, the appliance's lid (where present) must always be raised when using the oven. Heat the empty appliance to the maximum temperature in order to remove any manufacturing residues which could affect the food with unpleasant odours. 15 Instructions for the user 7. 7 Electronic programmer LIST OF FUNCTIONS Timer key End of cooking key Cooking duration key Value decrease key Value increase key 7. 7. 1 Setting the time On the first use, or after a power failure, will be flashing on the oven's display. Press the and keys together, and at the same time press the or keys: this will increase or decrease the setting by one minute for each pressure. Press either of the value modification keys to display the current time. 7. 7. 2 Using the timer Warning: the timer does not stop the cooking operation. It only warns the user that the preset number of minutes has passed. The programmer can also be used as an ordinary timer. Press ; press and hold and use or and ; the display will show the numbers is to set the required number of minutes. When will appear on the display. released, the countdown will start and After the timer has been programmed, the display will go back to showing the current time; to display the remaining time, press . 7. 7. 3 Stopping the buzzer The buzzer stops automatically after about seven minutes. [. . . ] In case of stubborn dirt, wash with a damp sponge and neutral detergent. Replacing the glass panels: · Replace the panels in the opposite order to which they were removed. · Reposition the internal glass panel, taking care to centre and insert the 4 pins attached to the glass into their slots in the oven door by applying slight pressure. 27 Instructions for the installer 11. INSTALLATION 11. 1 Installing in kitchen units Veneers, adhesives or plastic coatings on adjacent furniture should be temperature-resistant (no less than 90°C). If they are not sufficiently temperature-resistant, they may warp over time. [. . . ]