User manual SMEG FA410XS

[. . . ] Never place the appliance close to sources of heat such as cookers or radiators, and avoid placing it in direct sunlight. 600 600 Room temperature The climate class is stated on the nameplate (see fig. This specifies the optimum room temperature. Climate class SN N ST T Optimum room temperature +10 ºC to +32 ºC +16 ºC to +32 ºC 600 +18 ºC to +38 ºC 600 fig. 2 +18 ºC to +43 ºC Installation The surface on which the appliance is to be placed must be level. [. . . ] Rotate the hinge through 180° and refit it on the opposite side of the appliance. Remove the door closer and refit it on the opposite side. 10. Remember to pull the pin in the door closer towards the side before fitting the door. . 11. Remove the door handle and refit it on the opposite side. The appliance must be allowed to stabilise in an upright position for at least 1 hour before being switched on. 15. After reversing the door(s), it is important to check that the sealing strip provides a tight seal all the way round. If it does not, carefully heat the strip all the way round using a hair dryer. Then ease the strip outwards slightly so that it forms a tight seal against the cabinet. Be careful not to heat the strip so much that it melts! 7 GB Electrical connection The appliance is intended for connection to alternating current. The required voltage (V) and frequency (Hz) are stated on the nameplate inside the appliance. Power must be connected via an independent wall socket outlet. Technical data This appliance complies with CE marking regulations, directives and standards. 15 10 GB Defrosting, cleaning and maintenance Automatic defrosting The refrigerator is defrosted automatically. Defrost water runs through a pipe and is collected in a tray above the compressor where the heat generated by the compressor causes it to evaporate. The defrost water tray should be cleaned at intervals. Stainless steel or aluminium doors are best cleaned using a care spray and soft cloth. Various suitable products are available from most household appliance distributors. If the appliance is not to be used for any length of time, switch it off, empty it, clean the cabinet and fittings, and leave the door slightly open to allow air circulation and prevent smells. Cleaning Disconnect the power supply before cleaning the inside of the cabinet. The cabinet is best cleaned using warm water (max. Rinse with clean water and dry thoroughly. It is important to prevent water from entering the control panel. The defrost water channel, in which condensation from the evaporator runs, is located on the rear wall of the cabinet and must be kept clean. Rodalon, to the defrost water drain a couple of times a year, and clean the drain using a pipe cleaner or similar. [. . . ] Move the appliance away from the kitchen elements or appliances it is in contact with. Check movable fittings and adjust them if necessary. Distribute items within the cabinet to improve air circulation. Keep door closed. Temperature in refrigerator section too high. 12 GB Spare parts and service Spare parts When ordering spare parts, please state the type, serial and production numbers of your appliance (see fig. [. . . ]