User manual SMEG FAB10HRDS

[. . . ] SAFETY PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . INTENDED USE OF THE REFRIGERATOR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . INSTALLATION AND CONNECTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 3. 1 Choosing the site . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Warning: To avoid a hazard due to instability of the appliance, it must be fixed in accordance with the instructions. Warning: Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction. Warning: Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. Warning: Do not damage the refrigerant circuit. Warning: Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer. Caution: this refrigerator contains a small quantity of isobutane (R600a), a CFC-free gas refrigerant. When transporting, installing, cleaning and repairing the refrigerator, take care not to damage any parts of the refrigeration circuit to prevent the risk of gas leaks. In case of damage, do not use naked lights and ventilate the room containing the appliance appropriately. 2. INTENDED USE OF THE REFRIGERATOR The appliance is specifically constructed for domestic use and is therefore suitable for the refrigeration and storage of fresh foods. The appliance has not been designed or manufactured for professional use. Smeg declines all responsibility for damage deriving from improper use of the appliance. The refrigerator has undergone all necessary tests regarding tightness of the refrigeration circuit and complies with the safety regulations for electrical appliances. Caution: the manufacturer declines all responsibility for injury or damage caused by failure to comply with the above regulations or deriving from tampering with even just one part of the appliance and the use of non-original spare parts. 14 Instructions for the Installer 3. INSTALLATION AND CONNECTION 3. 1 Choosing the site Always place the refrigerator in a dry place with satisfactory ventilation. Never expose it to direct sunlight or install it outdoors. Depending on its climate class (stated on the nameplate), the appliance can be used in different temperature conditions: Class SN (Subnormal) N (Normal) ST (Subtropical) T (Tropical) Ambient temperature from + 10° C to + 32° C from + 16° C to + 32° C from + 18° C to + 38° C from + 18° C to + 43° C Never place the refrigerator close to heat sources. If this is unavoidable, a suitable insulating panel must be used to allow the appliance to function properly. Otherwise, place the appliance at least 3 cm from electric or gas cookers and at least 30 cm from combustion or radiation heating systems. To allow proper cooling of the condenser, the refrigerator must not be placed too close to the wall. To prevent this, the appliance comes complete with two plastic spacers which must be fitted to the top of the condenser. If the refrigerator is installed underneath a wall cupboard, the distance between the two must be at least 5 cm. Take care not to scratch or damage the floor when installing the appliance on parquet or linoleum. [. . . ] Do not place hot foods in the refrigerator section. Wait for foods and drinks to cool to room temperature before placing them on the shelves; Open the door(s) as infrequently and for as short a time as possible to prevent the compartments from warming up too much; Clean the condenser (rear of the refrigerator) periodically to prevent the appliance from losing efficiency; On models equipped with intensive cooling and rapid freezing, do not leave these functions activated for longer than absolutely necessary; If the refrigerator is to be out of use for a long period, it is best to empty it and switch it off; 18 Instructions for the user 6. 5 Operating noise The refrigerator is cooled by means of a compression system. In order to maintain the preset temperature inside the refrigerator section, the compressor comes into operation in response to the level of cooling required, and may operate continuously if necessary. When the compressor starts up a humming sound will be heard, tending to drop in volume after a few minutes. [. . . ]