User manual SMEG FAB28RX

[. . . ] SAFETY PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . INTENDED USE OF THE REFRIGERATOR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . INSTALLATION AND CONNECTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22 3. 1 Choosing the site . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If the refrigerator is installed underneath a wall cupboard, the distance between the two must be at least 5 cm. Take care not to scratch or damage the floor when installing the appliance on parquet or linoleum. If necessary, when positioning slide the refrigerator over pieces of wood or a mat to the point decided for connection to the electrical mains. 3. 2 Positioning and levelling the appliance Place the fridge on a stable and level floor. In case the floor is not perfectly level, use the two adjustable feet on the front part of the fridge (pict. To ensure major stability, easier movement and a correct positioning of the product, two additional wheels (pict. In any case we recommend to move the fridge very carefully in order to avoid floor damage (especially in case of wooden floor). 1) 2) 3. 3 Electrical connection Before switching the refrigerator on for the first time, leave it vertical for at least two hours. Then connect the appliance's power supply lead to a mains socket with earth contact, installed in accordance with electrical safety regulations. The rated voltage and frequency are stated on the nameplate inside the refrigerator compartment. The appliance must be connected to the electrical mains and earthed in compliance with the relevant regulations and requirements. The appliance is able to withstand short fluctuations in voltage of no more than 15% less or 10% more than the rated voltage stated on the nameplate. The bottom of the door has a shelf to take vertical bottles. All door shelves and boxes can be removed for cleaning. To remove them from the door, tap them upward with your fist in the first on one side of the insertion zone and then on the other. Do not place excessively heavy bottles on the bottle shelf, and place bottles on the shelf gently when loading them (Fig. 1). Fig. 1) 4. 7 Inside lighting When the refrigerator door is opened, the light comes on; it remains on until the door is completely closed again. The light comes on even if the refrigerator thermostat is set on "0", meaning that the refrigerator is switched off. 4. 8 Fan The fan helps keep the temperature well distributed and reduces condensate on the shelves. 24 Instructions for the User 5. ARRANGING FOODS COMPARTMENT INSIDE THE REFRIGERATOR Arrange the foods on the various shelves, taking care that they have an airtight wrapping or cover. This precaution will: - conserve foods' fragrance, moisture and freshness; - prevent the cross-contamination of foods with different aromas and tastes; - prevent the humidity level inside the refrigerator becoming too high because of the normal breathing of food (especially fresh fruit and vegetables). In some operating conditions (rise in ambient temperature and humidity, more frequent opening of the door) this might cause condensation to form on the shelves. Use only containers approved for food storage. Always allow hot foods and drinks to cool to room temperature before placing them inside the refrigerator. Never store explosive substances in the appliance and only store high-alcohol drinks firmly sealed and vertical. 6. [. . . ] This noise is perfectly normal and does not mean that the appliance is malfunctioning. If it is over-loud, there may be other causes. In this case, check that: - the refrigerator is properly levelled on the floor and does not vibrate when the compressor is in operation: adjust the feet provided as appropriate; - The drawers, shelves and door boxes are correctly fitted and securely in place: fit correctly; - Bottles and containers on the various shelves are stable and not touching: the vibration due to operation of the compressor may generate some noise; - Do not place kitchen units or other appliances so that they are touching the refrigerator. 8. 7 Identifying and Dealing with Malfunctions Your new refrigerator is designed and built to strict quality standards. This section is intended to enable you to identify the origin of any malfunctions which may occur before contacting the Smeg After-Sales Service. 8. 8 Changing the inside light bulb Before replacing the bulb, make sure that its failure to operate is not simply because it has become loose inside the lamp holder. [. . . ]