User manual SMEG FAB32JP

[. . . ] SAFETY PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . INTENDED USE OF THE REFRIGERATOR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . INSTALLATION AND CONNECTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 3. 1 Choosing the site . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] To remove them from the door, tap them upward with your fist in the first on one side of the insertion zone and then on the other. Do not place excessively heavy bottles on the bottle shelf, and place bottles on the shelf gently when loading them (Fig. 1). When removing bottles, do not pull them in a diagonal direction as this may over-strain the retainer rod (Fig. 2). Fig. 2) 4. 9 Cheese box A special cheese box with lid is supplied (depending on model). This box can be placed on any shelf as required. 4. 10 Inside lighting When the refrigerator door is opened, the light comes on; it remains on until the door is completely closed again. The light comes on even if the refrigerator thermostat is set on "0" (stop), meaning that the refrigerator is switched off. 4. 11 Fan (on some models only) The fan helps keep the temperature well distributed and reduces condensate on the shelves. It does not work when the refrigerator door is open. Turning on the fan is recommended when the ambient temperature and relative humidity are high. To stop it, just set the switch on the symbol 0 Electric energy consumption rises when the fan is operating 9 Instructions for the user 5. ARRANGING FOODS COMPARTMENT INSIDE THE REFRIGERATOR Arrange the foods on the various shelves, taking care that they have an airtight wrapping or cover. This precaution will: - conserve foods' fragrance, moisture and freshness; - prevent the cross-contamination of foods with different aromas and tastes; - prevent the humidity level inside the refrigerator becoming too high because of the normal breathing of food (especially fresh fruit and vegetables). In some operating conditions (rise in ambient temperature and humidity, more frequent opening of the door) this might cause condensation to form on the shelves. Use only containers approved for food storage. Always allow hot foods and drinks to cool to room temperature before placing them inside the refrigerator. Never store explosive substances in the appliance and only store high-alcohol drinks firmly sealed and vertical. 6. SETTING AND SELECTING THE OPERATING TEMPERATURE The knob in the top right-hand corner of the refrigerator is used to set the operating temperature both in the refrigerator and in the freezer. When the knob is turned to 0 ("stop"), the appliance is switched off. There is no direct correspondence between the setting chosen and the temperature in the two sections of the appliance. Increasing the setting number reduces the temperature inside the appliance. Only use the highest settings (6-7) if absolutely necessary: with these settings, the temperatures inside the refrigerator compartment may be close to 0°C and electricity consumption will be higher. In normal operating conditions, a medium-low setting (2-3) is recommended. This will provide effective storage of the fresh foods in the refrigerator compartment and of the frozen foods in the freezer compartment. [. . . ] In this case, check that: - the refrigerator is properly levelled on the floor and does not vibrate when the compressor is in operation: adjust the feet provided as appropriate; - The drawers, shelves and door boxes are correctly fitted and securely in place: fit correctly; - Bottles and containers on the various shelves are stable and not touching: the vibration due to operation of the compressor may generate some noise; - Do not place kitchen units or other appliances so that they are touching the refrigerator. 9. 7 Identifying and Dealing with Malfunctions Your new refrigerator is designed and built to strict quality standards. This section is intended to enable you to identify the origin of any malfunctions which may occur before contacting the Smeg After-Sales Service. 9. 8 Changing the inside light bulb Before changing the bulb, make sure that the light has not stopped working simply because the part inside the lamp socket has become loose. In all cases, whether you wish to check that the socket is connected correctly or change the bulb, for safety reasons the plug must be removed from the power socket. Use your fingers to squeeze the cover (in the direction shown by the arrow 1) to remove it from its seat. [. . . ]