User manual SMEG FAB50PO

[. . . ] SETTING AND SELECTING THE OPERATING TEMPERATURE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . MAINTENANCE AND CLEANING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 6. 1 Defrosting the refrigerator compartment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 6. 2 Cleaning the refrigerator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The appliance's electrical safety is only guaranteed if the household electrical system is earthed in accordance with the relevant regulations. - Make sure that all repairs and servicing are only carried out by authorised engineers from the Smeg after-sales service. Always disconnect the appliance from the electrical mains in case of breakdown and maintenance, when changing light-bulbs or during cleaning. Never defrost using electrical devices or steam cleaners. Never remove frost or ice with sharp items, as this may cause irreparable damage to the walls of the refrigerator. - Never attempt to move the refrigerator by pulling on the door or the handle. - Do not use electrical equipment (such as ice cream makers or blenders) inside the appliance. - To ensure the refrigerator operates correctly, never obstruct or cover the air ducts in any way. - Never eat or drink foods which look or smell strange. - Never allow children to play with the refrigerator and use the drawers, shelves or other parts of the appliance only as described in this handbook; never use them for purposes other than those for which they are designed. In case of electricity blackout, open the door(s) as little as possible. Then connect the appliance's power supply lead to a mains socket with earth contact, installed in accordance with electrical safety regulations. The rated voltage and frequency are stated on the nameplate inside the refrigerator compartment. The appliance must be connected to the electrical mains and earthed in compliance with the relevant regulations and requirements. The appliance is able to withstand short fluctuations in voltage of no more than 15% less or 10% more than the rated voltage stated on the nameplate. If the power supply lead has to be replaced, this operation must only be carried out by an authorised Smeg technical service engineer. The power plug must be accessible after the appliance has been installed. 15 Instructions for the user 4. PRODUCT DESCRIPTION Inside light and thermostat knob. Bottle shelf Defrosting water collection channel. Bottle retainer strut. 4. 1 Shelves The refrigerator comes complete with several shelves which can be set at different heights by placing them on the runners provided. Each shelf has a safety fitting to prevent it from being pulled completely out or accidentally removed. To remove it from the appliance, lift it at the back and extract it. [. . . ] In normal operating conditions, a medium-low setting (1-2) is recommended. This will provide effective storage of the fresh foods in the refrigerator compartment. Important Changes in weather conditions (temperature and humidity) and the frequency with which the door is opened may affect the refrigerator's operating temperatures. 17 Instructions for the user 6. Then empty the compartments, disconnect the appliance from the electrical mains, and once it has defrosted dry any residual moisture which has collected. Leave the door ajar to prevent the humidity and trapped air from creating unpleasant smells. 6. 4 Practical advice for saving energy Install the refrigerator in a cool, well ventilated place, protected against direct sunlight and well away from heat sources. [. . . ]