User manual SMEG FC66X

[. . . ] INSTRUCTIONS FOR USE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . INSTRUCTIONS FOR DISPOSAL ­ OUR ENVIRONMENTAL CARE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35 SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36 GET TO KNOW YOUR OVEN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] After setting the duration, press PT1 once. The symbol and the current time will appear on the display. Turning PT1 to the right increases the time, allowing the cooking start time required to be set. A few seconds after the required duration is set, the and symbols will stop flashing and remain constantly on, and the oven will start to wait for the starting time set. At the end, the word STOP will appear on DSP1, cooking will stop and a buzzer will sound; press PT1 once to deactivate it. If you wish to continue cooking beyond the set time, press PT1 again. The oven will restart normal operation with the cooking settings selected previously. To switch the oven off completely, PT2 must be turned to 0. Modifying the data set Once automatic cooking has started, its duration can be changed. When the and symbols are steady and cooking is in progress, or the oven is in standby status waiting for cooking to start, press PT1 once. The symbol starts flashing and PT1 can be turned to change the set duration. Press PT1 again; the symbol goes out, the symbol will start to flash, and the cooking start time will be displayed on DSP1. The cooking start time can be increased or decreased by turning PT1. A few seconds after the last change, the and symbols will appear (in steady mode) on DSP1 and automatic cooking will restart with the new settings. 43 Instructions for the user 7. 6 Secondary menu This product also has a "secondary menu" that allows the user to: 1 2 Set the time shown on the display (DSP1). (P1: OF / ON) Activate or deactivate the child safety device ( ); this function, after 2 minutes of operation without any actions by the user, activates locking of all the functions and knobs; it is identified by the appearance of the ( ) symbol on DSP1. To temporarily deactivate locking and modify a cooking programme or selects a different function, keep PT1 pressed down until the ( ) symbol disappears from DSP1. At this point you can make the desired changes, and 2 minutes after the last setting, locking will be reactivated. To permanently deactivate locking you have to enter the secondary menu and deactivate it as described in this paragraph. (P2: OF / ON) Activate or deactivate the Show Room function; this function disables all the heating elements so that only the control panel works (To use the oven normally, set P2:OFF). 3 4 (P3: OF / ON) Activate or deactivate the function that allows a maximum consumption of 2300 W. When the child safety device is activated (P1:ON), if a knob is moved "bLOC" is displayed on DSP1 for 2 seconds. An action on PT2 also activates the "BLOC" alarm until the function originally selected is restored. 44 Instructions for the user 7. 6. 1 Change the settings in the secondary menu The secondary menu appears at first use, after a power failure or by holding PT1 down for 3 seconds with the oven in the OFF position (see point "7. 2 Operating modes"). Changing the parameters in the secondary menu is very simple. [. . . ] The panes of glass can now be washed separately. 58 Instructions for the user 1) 2) 3) Use absorbent kitchen roll; remove stubborn dirt with a damp sponge and ordinary detergent. Warning: before removing the panes of glass, make sure that the door has been locked in an open position as described in points "12. 2 Removing the door". This operation might also have to be repeated during the glass removal process if the door is accidentally freed. To reassemble the door glazing, follow the provided instructions in reverse order. [. . . ]