User manual SMEG FD238AF

[. . . ] 10 Sbrinamento del reparto freezer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Pulizia e manutenzione . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Consigli pratici e osservazioni . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Problemi di funzionamento e loro risoluzione . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The appliance climate class is N. Model Total gross volume, L Freezer gross volume, L Refrigerator net volume, L Freezer net volume, L Temperature in the refrigerator compartment, °C Temperature in the freezer compartment, °C Dimensions (HxWxD), cm Energy efficiency class according to the directive 94/2 E Energy consumption, kWh/24 h Freezing capacity, kg/24 h Freezer temperature rising time from storage temperature to -9 ºC after power-cut, h Rated input, W Voltage used, V/Hz FD24AP 220 46 166 46 from 0 to +10 -18 and lower 144x56x60 A 0, 75 2 17 105 220-240V/50Hz NOTE. The manufacturer reserves the right to make future changes to technical parameters and specifications. 16 GB DESCRIPTION OF THE APPLIANCE, BASIC PARTS !THE APPLIANCE ACCESSORIES LISTED BELOW MAY DIFFER FROM THE ACCESSORIES OF THE APPLIANCE YOU HAVE BOUGHT IN QUANTITY AND IN DESIGN. THIS DESCRIPTION IS ADAPTED FOR ENTIRE GROUP OF REFRIGERATORFREEZER COMBINATIONS. 1 A ­ refrigerator compartment B ­ freezer compartment 1. Thaw water channel cleaner (red colour) 11. If you have purchased a refrigerator with vertical boor handles: · Take the handles out of the bag and screw them onto the refrigerator door. · Cover the heads of the screws with the little caps that you will find in the bag POSITIONING · Place the appliance in a dry, well ventilated room. · The appliance should not be operated in an unheated room or porch. Place the appliance away from heat sources such as kitchen stove/oven, radiators, or direct sunlight. · The appliance must not touch any pipes for heating, gas or water supply, or any other electrical devices. Remove the two supports 1 at the top back part of the refrigerator and undo the screws 2. Undo the two screws 3 that hold the pullout shelf. Take off bracket 5 with the spacers that are on the shaft. Remove middle bracket 7 together with the washers that are on the shaft. Remove middle bracket 9 together with the washers that are on the shaft. Unscrew the shaft by turning it counter-clockwise. Turn bracket 9 around a full 180° and screw the shaft back in. Remove caps 10 from refrigerator and freezer compartment doors and press them in on the opposite side. Remove decorative caps 11, unscrew bolts from the partition separating the refrigerator and freezer compartment, and screw them in on the opposite side. Replace the decorative caps on the bolts. Mount refrigerator compartment door on the shaft of bracket 8. [. . . ] Check that the appliance is standing stable, on a level place To make it level, regulate the front feet. Check if the appliance is not touching any furniture, and that no part of the refrigeration system at the back part of the appliance body is touching the wall. Pull the appliance away from any furniture or walls. Check that the cause of increased noise isn't due to bottles, cans or dishes in the appliance that might be touching each other. [. . . ]