User manual SMEG FD240APS

[. . . ] REFRIGERATOR OPERATING INSTRUCTIONS MODEL: Dear customer, Before placing your new refrigerator/freezer into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. [. . . ] Refit the bracket fitting the bottom hinge pin. Transfer the lower door to the property position. Secure the door's level, make the bottom hinge pin into the lower hole of the door, then tight the bolts. 8. Make the middle hinge reverse the direction 180 degree, then transfer it to the left property position. Make the middle hinge pin in the upper hole of the lower door, then tight the bolts. Transfer the upper door to the property position. Secure the door's level; make the middle hinge pin into the lower hole of the upper door. 9. Unscrew and remove the top hinge pin, turn the bracket over and replace it. Tighten securely. 8 10. Remove the screws and the plastic blanking plate and replace them on the opposite side cabinet. 11. Transfer the top hinge to the left property position. Make the top hinge pin into the upper hole of the upper door, then tight the bolts, tight the screws to secure the door. 12. Replace the lid by fitting the front first and sliding into place, securing it with the two screws . Replace the screw covers. Warning!When changing the side at which the door opens, the appliance must not be connected to the mains. Remove plug from the mains beforehand. 9 Description of the appliance View of the appliance 1. Ice tray 2. 3. Temperature regulator 4. Storage shelves 5. Crisper cover 6. Crisper 7. Door shelves(eggs tray inside the upper shelf) Starting up and temperature regulation Insert the plug of the connection lead into the plug socket with protective earth contact. The water from the thawing frost evaporates by itself. Switching off the appliance To switch off the appliance, turn the temperature regulator to position "0". If the appliance is not going to be used for an extended period: Remove all refrigerated packages. Switch off the appliance by turning the temperature regulator to position "0". Remove the mains plug or switch off or disconnect the electricity supply. Clean thoroughly (see section: Cleaning and Care) Leave the door open to avoid the build up of odors. Cleaning and Care For hygienic reasons the appliance interior, including interior accessories, should be cleaned regularly. The appliance may not be connected to the mains during cleaning. Before cleaning switch the appliance off and remove the plug from the mains, or switch off or turn out the circuit breaker or fuse. [. . . ] At the same time shape the warmed door seal by hand such that it sits correctly. The appliance is touching the wall Move the appliance slightly. If necessary, carefully bend A component, e. g. a pipe, on the the component out of the rear of the appliance is touching way. [. . . ]