User manual SMEG FR2392P

[. . . ] The ideal temperatures for the storage of foodstuffs are pre-set in the factory What to do if. . . Possible causes Cure Make sure: • there is not a power failure • the plug is properly inserted in the power socket and the double-pole switch (if present) is in the correct position (on) • the household electrical system protection devices function • the power cable is not broken. • the thermostat knob is not turned to "•" The appliance doesn't work. There may be an appliance power supply problem. Disconnect the appliance from the power supply, check the light bulb and, if necessary, replace it with a new one (see the section "Light bulb or LED replacement"): - traditional light bulb (25 W max. ) The inside light doesn't work. Or - LED bulb (with the same characteristics), only available from the After-Sales Service LED bulb Light bulb The temperature inside the compartments isn't low enough. There could be various causes (see the column "Cure"). Make sure: • the doors are properly closed • the appliance is not installed near a heat source • the temperature set is appropriate • the circulation of air through the ventilation grilles at the bottom of the appliance is not obstructed. Water on the bottom of the refrigerator compartment. The defrost water drain is obstructed. Clean the defrost water drain hole (see the section "Appliance maintenance and cleaning") 12/11 Read the user handbook carefully before using the appliance. [. . . ] Note: the ambient temperature, door opening frequency and position of the appliance can affect the temperatures inside the two compartments. Set the temperature based on these factors. Making ice cubes Fill the ice cube tray (where provided) 2/3 full and place it in the freezer compartment. Never use sharp or pointed objects to remove the ice. Removing drawers (depending on model) Pull the drawers all the way out, lift them up a little and remove. To create more space, the freezer compartment can also be used as follows: A) If the freezer compartment base resembles figure A, remove the upper drawers and/or lids. The lower drawer should be left in position. Make sure that, once the food has been placed on the racks/shelves, the door closes properly. B) If the freezer compartment base resembles figure B, remove all drawers or lids. Make sure that, once the food has been placed on the racks/shelves, the door closes properly. Removing the lid (if present) Open the lid and remove the pin, as illustrated in figure C. A B C DEFROSTING THE FREEZER COMPARTMENT (depending on the model) No Frost models do not need defrosting. For other models, if frost forms in the freezer compartment, we recommend it is defrosted twice a year or whenever an excessive amount of frost has formed (3 mm thickness). It is perfectly normal for frost to form. The amount of frost which forms and the rate at which it builds up depends on room temperature and humidity, and on how often the door is opened. To defrost, unplug the appliance and remove all foodstuffs. Leave the door ajar to allow the frost to melt. For products with a freezer compartment below the refrigerator compartment, the defrost water drain pipe can be removed (see figure) and a recipient placed underneath. After defrosting, replace the drain pipe, making sure that no water is left in it. Clean inside the freezer compartment and dry carefully. Switch the appliance back on and place the food back inside. 12 MEAT & FISH BOX (depending on model) The Meat & Fish box was designed specially to keep foods fresher for longer, without altering nutritional values or original freshness. Do not store fruit or vegetables in this box, as the temperature may drop below 0°C, causing water contained in the food to freeze. Temperature Adjustment The temperature inside the Meat & Fish box is indicated by the position of the arm on the door of the box, and depends on the general temperature of the refrigerator compartment. We recommend setting the temperature of the refrigerator compartment between +2° and +6°. [. . . ] Na het afstellen van het scharnier controleren of er geen direct contact is tussen de houten deurtjes en de zijkanten van het meubel, dit om een correcte sluiting te garanderen. Tras haber regulado los dispositivos de acoplamiento, asegurarse de que las puertas de madera no toquen directamente los flancos de la columna para asegurar un cierre correcto del aparato. Depois de ter regulado a guia, assegurar-se de que as portas de madeira não fiquem em contacto directo com os flancos da coluna a fim de garantir que o aparelho feche correctamente. Dopo aver regolato il traino assicurarsi che non ci sia contatto diretto delle portine in legno con i fianchi della colonna per garantire una corretta chiusura del prodotto. Αφού ρυθμίσετε τον οδηγό βεβαιωθείτε ότι δεν υπάρχει άμεση επαφή ανάμεσα στα ξύλινα πορτάκια και τις πλευρές της κολόνας για να εξασφαλιστεί το σωστό κλείσιμο του προϊόντος. [. . . ]