User manual SMEG FTH380

[. . . ] GETTING TO KNOW YOUR COOKER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . DESCRIPTION OF FRONT PANEL CONTROLS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . USING THE HOB . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . USING THE OVEN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] NOTES 1 Requirement 3 does not apply to a freestanding or elevated cooking appliance which is designed to prevent flames or the cooking vessels from extending beyond the periphery of the appliance. 2 The `cooking surface area' is defined as that part of the appliance where cooking normally takes place and does not include those parts of the appliance containing control knobs. 3 For definition of hob, see Clause 1. 4. 64. 4 For definition of trivet, see Clause 1. 4. 109. 5 Consideration is to be given to window treatments when located near cooking appliances. 8 Instructions for the installer 2. 6 Instruction for wall fixing 1 Fasten the two wall brackets to the wall taking care to comply with the centre distances and measurements indicated in the images below. A= 262 / B = 218 A 170 B 2 3 4 5 900 A B Attach the chain to the cooker Stretch out the chain attached to the cooker horizontally so that the other end touches the wall. Mark the wall in the position where the hole is to be drilled. Drill the hole, insert a wall plug and attach the chain. 6 Once these operations are completed, push the appliance against the wall taking care to insert the wall brackets correctly in the slots on the back of the cooker. 9 Instructions for the installer 3. ADAPTATION TO DIFFERENT TYPES OF GAS Before performing any operations requiring access to powered parts, switch off the power supply to the appliance. The cooker hob is preset for natural gas at a pressure of 1. 0 KPa. Ventilation will start working when the oven has reached a temperature of about 120-130 °C. GRILL ELEMENT FAN-ASSISTED HEATING ELEMENT GRILL ELEMENT THAWING 16 Instructions for the user 7. USING THE HOB 7. 1 Lighting the hob burners Before lighting the hob burners, check that the flame-spreader crowns are correctly in place with their respective burner caps, making sure that the holes A in the flame-spreaders are aligned with the plugs and thermocouples. Before lighting the burners lift the glass lid; before closing it again, turn off all the burners and wait for them to cool. The optional grid B is for use with woks. To prevent damage to the hob, the cooker comes complete with a raised pan stand C for use underneath pans more than 26 cm in diameter. The pan stand C supplied is for use even with small pans. The burner each knob controls is shown next to the knob. The appliance is equipped with an electronic ignition device. Simply press the knob and turn it anti-clockwise to the minimum flame symbol , until the burner lights. Keep the knob pressed down for a few seconds to allow the thermocouple to heat up. The burner may go out when the knob is released: in this case, the thermocouple has not heated up sufficiently. Repeat the operation, keeping the knob pressed down for longer. [. . . ] If they dry for too long, they might damage the enamel coating of the inside of the oven. 10. 4 The burner caps, flame diffuser rings and burners The burner caps and flame diffuser rings can be removed for easier cleaning; wash them in hot water and non-abrasive detergent, taking care to remove all deposits, and wait for them to dry completely. Replace the burner caps on their rings, making sure that the holes A are perfectly centered with the circular projections B on the burners. Never wash these components in the dishwasher. 10. 5 The plugs and thermocouples For best performance, the ignition plugs and thermocouples must always be kept thoroughly clean. Check them frequently and if necessary clean them with a wet cloth. Remove any dry residues with a wooden toothpick or a needle. 21 Instructions for the user 10. 6 Cleaning the oven For best oven upkeep clean regularly after having allowed to cool. [. . . ]